Add_workflow_for_techpubs |
---|
AUTH1 | |
---|
JIRAIDAUTH | SBX-98014 |
---|
REV5 | |
---|
REV6 | |
---|
REV3 | |
---|
REV1 |
---|
|
...
Re-installing a SBC system from an ".iso" image followed by restoring SBC configuration from a tar.gz backup file may lead to loss of encrypted configuration parameters in the following scenarios:
- re-installing a standalone SBC from an ".iso" image followed by restoring SBC configuration from a "tar.gz" backup file
- re-installing both nodes in an HA SBC pair from an ".iso" image followed by restoring SBC configuration from a "tar.gz" backup file
...
For details please refer to Sonus Warning: Warning-17-00022737.
Perform the following steps to restore the
configuration using CLI: Multiexcerpt include |
---|
MultiExcerptName | SBC SWe Cloud restore limitation |
---|
PageWithExcerpt | Saving the SBC Configuration using CLI |
---|
|
Log on to the remote server where you have copied the configuration files, as described in Saving the SBC Configuration.
Execute the following commands to copy the files to your SBC system:
Code Block |
---|
|
% cd /home/bob/SBC01/config
% sftp -oPort=2024 |
...
admin@SBC01a
Connecting to SBC01a
|
...
admin@10:54:19.17's password: xxxxxxx
sftp> put config_SBC01_20170324_021127.tar.gz /var/log/sonus/sbx/config/ |
To view the saved configuration files, use the following CLI command:
Code Block |
---|
|
admin@SBC01a> show table system savedConfigList
INDEX FILE NAME SIZE
----------------------------------------------------------
1 config_SBC01_20170324_021127.tar.gz 1061 KBytes |
- Log on to SBC CLI, and load the configuration by executing the following CLI command:
Code Block |
---|
|
admin@SBC01a> request system admin SBC01 loadConfig fileName config_SBC01_20170324_021127.tar.gz
This command will load the last saved configuration and restart the applications on active/standby servers. Do you want to continue (yes/no) y
Proceeding
result success
reason Starting DB restoration from: config_<server name>_20170324_021127.tar.gz please check /var/log/messages for progress |
Info |
---|
You must follow the procedure below to activate the traffic profile during loadConfig scenarios; loadConfig does not activate the profile To configure the required profiles you must first reset the profile to default, and then set desired profile. 1. Note the current active profile from CLI (xxx_profile ). 2. After loadConfig is done, activate the default profile in the system because the system will be in default profile. 3. After the system comes up after a reboot, activate the old active profile (for example, xxx_profile). |
Info |
---|
|
When you load config dump taken from SBC versions older than 8.0, the loadConfig process internally converts Oracle based policy dump to the Postgres format. This process takes approximately 25 minutes to complete. |
Warning |
---|
This command will restart application on both the servers and is service impacting.
|
Info |
---|
|
When reloading a saved configuration, make sure the standby server is stable or the server is reachable. If the standby is restarted or rebooted, wait until the server is stable before proceeding. If the standby system crashes before the load config completes, stop the standby server and allow the original active server to come back online as active. |