This article describes the steps necessary to modify the
(SBC) configuration such that the SIP Transport is changed from TLS/SRTP (MTLS/SRTP) to TCP/RTP.
...
PBX – SBC – Microsoft Lync 2010 configuration in place with MTLS/SRTP as SIP Transport |
---|
Image Modified |
Topology After
PBX – SBC – Microsoft Lync 2010 configuration in place with TCP/RTP as SIP Transport |
---|
Image Modified |
SBC Configuration Changes
...
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | SIP Signaling Group Before |
---|
| Image Removed |
|
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | SIP Signaling Group After |
---|
| Image Removed |
|
...
| Image Added |
|
Media List
- In the WebUI, click the Settings tab.
In the left navigation pane, go to Media > Media List > (relevant media list entry).
This is the Media List specified in the SIP Signaling Group above. |
Change the Crypto SDES-SRTP Profile ID value to None as shown below.
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Media List Before |
---|
| Image Removed |
|
Panel |
---|
|
Caption |
---|
| Image RemovedImage Added |
|
SIP Server Table
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to SIP > SIP Server Tables >(relevant SIP Server Table Entry).
- Change the Port value to 5068, as shown below.
Change the Protocol value to TCP, as shown below.
...
...
SIP Server Table Before | Image Removed |
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | SIP Server Table After |
---|
| Image Removed |
|
...
Image Added |
|
Lync Changes (Topology Builder)
...
- Log into the Lync front end server PC.
- Launch the Lync Server 2010 Topology Builder.
- In the Navigation Tree, go to Branch Sites > PSTN gateways > (relevant SBC entry).
- Right-click the relevant SBC.
- Select Edit Properties...
- Change the Listening Port for IP/PSTN gateway to 5068, as shown below.
- Change the SIP Transport Protocol to TCP, as shown below.
Click OK.
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | PSTN Gateway Properties Change |
---|
|
Image Removed
Publish Topology
To publish the topology:
- In the Topology Builder navigation tree, right-click Lync Server 2010.
Select Publish Topology....
Panel |
---|
|
Caption |
---|
| Image Modified |
|
Lync Mediation Server Service Restart
...