Page History

...

• An empty USB flash drive, 8GB or larger.
• The software image you would like to load. These can be obtained from the Ribbon SBC Edge Support Portal - Download Center.

Preparing the USB Flash Drive

...

1. Insert the prepared flash drive into one of the ASM USB ports of the

   Spacevars
   0 company

   SBC 1000/2000 system.

   • Updating the ASM Recovery Partition on the SBC 2000- directly plug it into the USB Port for the ASM.

     expand

     Noprint
     Click to read more... Toggle Cloak

     here to see where the ASM USB port is on the front of the Sonus SBC 2000 chassistrue

     Cloak
     title Click to read more...
     Click here to see where the ASM USB port is on the front of the Sonus SBC 2000 chassis
     Include Page
     SBC 2000 Front Panel	SBC 2000 Front Panel	nopanel

   • Updating the ASM Recovery Partition on the SBC 1000- directly plug it into the USB Port for the ASM.

     expand

     Noprint
     Click to read more... Toggle Cloak

     here to see where the ASM USB port is on the front of the Sonus SBC 1000 chassisnopanel

     Cloak
     title Click to read more...	Click here to see where the ASM USB port is on the front of the Sonus SBC 1000 chassis
     Include Page
     SBC 1000 Front Panel	SBC 1000 Front Panel
     true

2. In the WebUI, click the Tasks tab.
3. In the left navigation pane, under Application Solution Module, click Update ASM Recovery Partition.

4. Click the Apply button to begin the installation of the new image.

   Note
   Loading and installing the new image can take up to 10 minutes.

5. Wait for the following message to be displayed:

   Panel
   borderStyle none
   Caption 0 Figure 1 Image Installation Complete Image RemovedImage Added

    

    

6. Remove the USB flash drive from the system.

...