Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

SBC Network Configuration Summary - ISDN to TLS SIP Server

Panel
borderStylenone

Caption
0Figure
1ISDN to TLS SIP Server

 

Configuration Steps

Media Configuration for TCP/RTP

Configure the Media and TLS profile for the ISDN to TLS SIP Server call:

Media Configuration Steps

1. Ensure there is a media profile for your preferred codec.
2. Review the Crypto Profile.
3. Verify the Media list for Media and Crypto Profiles.
4. Verify the TLS Profile.

In the SIP Server Table:
5. Add a SIP Server Host for the FE/SBA FQDN and set the TLS profile.
6. Set the SIP Options and the TLS Reuse Parameters.

In the destination Signaling Group:
7. Set the Media List entry.
8. Set the Federated FE/SBA FQDN and port:5067/protocol:TLS/TLS Profile.
9. Set the SIP Server Table entry.

Call Routing Configuration

Configure a call route from ISDN to the TLS SIP Server as follows:

Call Configuration Steps

1. Create a translation table/entry to perform any necessary number translations.
2. Create a Call Route entry. Configure the translation table name and Egress SG, enable transcoding, and configure the appropriate media list entry.

In the Ingress SG:
3. Verify/Set the Call Route Table and incoming ISDN port.

Other Important Information

Info

You will still need to configure the SBC for the appropriate certificates in order to complete TLS calls.

Pagebreak