Versions Compared

Old Version 5

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to Customer Replaceable Units

Back to SBC 5400 CRUs

Panel

In this section:

Table of Contents
maxLevel3

Overview

Tooltip
tipUse ESD protective device

Image Modified

The

Spacevars
0model5
front Bezel is a Customer Replaceable Unit (CRU). The purpose of the Bezel is to encase the replaceable air filter and to identify the LED status indicators (Power, Status, Active, Alarm, Locator) on the front panel of the chassis, as shown in the figure SBC 5400 Bezel. The Bezel product code is SBC-5400-BEZEL.

Anchor
SBC 5400 Bezel
SBC 5400 Bezel

Caption
0Figure
1SBC 5400 Bezel

Image Modified

Parts and Tools Required

  • Electrostatic discharge (ESD) strap
  • Replacement Bezel (if swapping out the Bezel)

 

Note

To prevent damage from electrostatic discharge, an ESD strap is provided in the accessory kit. See Connecting ESD Wrist Strap to install it.

 

Removing/Replacing the Bezel

Note
The Bezel can be removed with power applied to SBC chassis, hence do not shut down the SBC to remove the Bezel.

Perform the following procedure to replace the Bezel:

  1. Locate the tab on the left side of the Bezel and pull back on Bezel until the left ball stud mounts disengage from the chassis.

    Caption
    0Figure
    1Locating the tab on the Bezel

    Image Modified

    Caption
    0Figure
    1Disengaging Bezel from the SBC 5400 chassis

    Image Modified

  2. Grasp the right-side of the Bezel and pull the Bezel away from the chassis until the right ball stud mounts disengage from the chassis.

    Caption
    0Figure
    1Pulling out the Bezel from the chassis

    Image Modified

  3. Install the replacement Bezel assembly by aligning the ball stud mounts to the receiving sockets, and then gently push the Bezel until it is secured to the chassis.

CRU Storage

Tooltip
tipESD protective device

Image Modified

All 

Spacevars
0model5
CRUs are shipped in electrostatic discharge bags and should be handled using appropriate ESD precautions.

The storage environment for the CRUs are:

  • Humidity must be less than 95% (non-condensing)
  • Temperature must be between -40C and +70C

Pagebreak