Page History

CSS Stylesheet
img.confluence-embedded-image { display: inline-block !important; }

Add_workflow_for_techpubs

AUTH1	UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d00038a00a02355cd1c2f0155cd26cb41059c, userName='null'}
JIRAIDAUTH	SYM-2720827516
REV5	UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'}
REV6	UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'}
REV3	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cdb40a89, userName='null'}
REV4	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c99e02c08a00a02355cd1c2f0155cd26cc5207f0, userName='null'}
REV1	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ce5f0b8d8a00a02355cd1c2f0155cd26c7f0006a, userName='null'}
REV2	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ca2f03d1, userName='null'}

info

Panel

In this section:

Table of Contents

maxLevel	3

Support for an SBC behind a NAT is in SBC Edge 1000/2000 Release 8.0.2 and later only; support in SBC SWe Lite is planned for a later release.

This Best Practice includes instructions for migrating an

Spacevars

0	product

(either

Spacevars

0	longproduct

or

Spacevars

0	product3

) from Microsoft Teams Direct Routing Non Media Bypass (implemented on an SBC) to Microsoft Teams Direct Routing Media Bypass.

...

Info
If Microsoft Teams Direct Routing is not configured on the SBC Edge, refer to Best Practice - Configuring SBC Edge for to Microsoft Teams Phone System Direct Routing - On - Premises Deployment.

Prerequisites

Microsoft Teams Direct Routing must be configured on the SBC Edge. Refer to Best Practice - Configuring SBC Edge for to Microsoft Teams Phone System Direct Routing - On - Premises Deployment.
The applicable firewall port on the SBC Edge must be opened . Refer to: Firewall Settings.

Info
For Media Bypass, the following is supported: Deployment on a Public IP address Deployment behind NAT

...

In the WebUI, click the Settings tab.
In the left navigation pane, go to Signaling Groups.
Select the Signaling Group used for Microsoft Teams Direct Routing.
From the RTCP Multiplexing drop down list, select Enable.
Caption
0 Figure
1 Enable RTCP Multiplexing
From the ICE Support drown drop down list, select Enable.
From the ICE Mode drop down list, select Lite.
Caption
0 Figure
1 Enable ICE Support

Note
Before configuring Outbound NAT Traversal, obtain the Public IP address for your network (the Public IP address specified in the screen graphic is an example only).
For deployment behind a NAT only:
1. From the Outbound NAT Traversal drop down list, select Static NAT.
2. From the NAT Public IP (Signaling/Media) drop down list, enter the Public IP Address assigned on this media port (the Public IP used in the screen is an example only; use the Public IP for your network).
  Caption
  0 Figure
  1 Enable NAT
Click Apply.

...