Page History

The Link Monitor object allows you to monitor a link for a specific interface and belongs to a link detection group. Link Monitor verifies transport on a specific interface via Layer 3 ICMP/ARP/NUD to a specific destination, or monitors Media Independent Interface (MII) state for the physical port.

A new Link Monitor is created

on an interface for link verification. The Link Monitor is provided with a destination to use for link verification as well as the Link Detection Group to which it belongs. The Link Monitor is responsible for pinging that destination, processing responses and determining when the interface should be considered failed. It reports such failures to its Link Detection Group.

The active and standby SBC should be connected to different physical hardware (that is, switches) to avoid a single point of failure.

Each Link Monitor that is configured can also be configured with unique values for the Verify Timer, Response Timer, Reattempt Timer, and Maximum Retries. If configured, these values override the values configured for the Link Detection Group.

Each Link Monitor will set a timer while waiting to perform its next verification. The timeout for this timer is based on the configured Verify Timer value. When a ping is in progress and the Link Monitor is awaiting the response from the destination, a timer is set based on the configured Response Timer value. When the response times out and the Link Monitor retries, the Reattempt Timer value is used while waiting for the response.

When the number of consecutive failures reaches the Maximum Retries value, the Link Monitor considers the link verification as failed and reports this to its Link Detection Group.

While in the failed state, the Link Monitor will continue to attempt to ping the destination so that the failed condition can eventually clear. This is done at the rate specified by the Verify Timer.

The Link Monitor also supports a NULL destination (0.0.0.0), which disables the link verification for that interface. The interface is still considered failed if there is a hardware

failure.

To View Link Monitor

On SBC main screen, go to Configuration > System Provisioning > Category: Base Provisioning > Link Detection Group > Link Monitor. The Link Monitor window is displayed.

Caption
0 Figure 1 Link Monitor
Image Modified

The Link Monitor can be checked for each Address Context or for each Link Detection Group or for all the Address Contexts and Link Detection Groups created. Use the drop-down box to select the desired Address Context and Link Detection Group.

Caption
0 Figure 1 Link Monitor Main Field
Image Modified

To Edit Link Monitor

To edit any of the Link Monitors in the list, click the radio button next to the specific Link Monitor name.

Caption
0 Figure 1 Link Monitor Highlighted
Image Modified

The Edit Selected Link Monitor window is displayed below.

Caption
0 Figure 1 Link Monitor Edit Window
Image Modified

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Link Monitor

To create a new Link Monitor, click New Link Monitor tab on the Link Monitor List panel.

Caption
0 Figure 1 Link Monitor Fields
Image Modified

The Create New Link Monitor window is displayed.

Caption
0 Figure 1 Link Monitor Create Window
Image Modified

The following fields are displayed:

To Copy Link Monitor

To copy any of the created Link Monitor and to make any minor changes, click the radio button next to the specific Link Monitor to highlight the row.

Caption
0 Figure 1 Link Monitor Highlighted
Image Modified

Click Copy Link Monitor tab on the Link Monitor List panel.

Caption
0 Figure 1 Link Monitor Fields
Image Modified

The Copy Selected Link Monitor window is displayed along with the field details which can be edited.

Caption
0 Figure 1 Link Monitor Copy Window
Image Modified

Make the required changes to the required fields and click Save to save the changes. The copied Link Monitor is displayed at the bottom of the original Link Monitor in the Link Monitor List panel.

To Delete Link Monitor

To delete any of the created Link Monitor, click the radio button next to the specific Link Monitor which you want to delete.

Caption
0 Figure 1 Link Monitor Highlighted
Image Modified

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Caption
0 Figure 1 Link Monitor Delete Confirmation
Image Modified

Click Yes to remove the specific Link Monitor from the list.