Page History
Add_workflow_for_techpubs | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product. |
The following workflow defines the procedures to deploy for deploying HA on an SBC SWe Edge.
Prerequisites Anchor Prerequisites Prerequisites
Before you begin, make sure you have the following:
- Hardware Requirements
- Two SBC SWe Edge instances ESXi host with
- a minimum Minimum of 4 vCPUs
- a minimum Minimum of 4 GB of RAM
- a minimum Minimum of 3 to a maximum of 5 virtual network interface cards (NICs):
- 1 One for the Management port,
- 1 One or 3 three for Media/Packet ports
1 One for the HA port
Info title Note Regardless of whether Whether you choose to use 3 or 5 virtual NICs, the last Media/Packet port is converted to an HA port. You cannot configure the HA port for signaling and media call handling, as it is used for such purposes as fault detections detection and storing and retrieving data from the database store.
- all 5 Five network interfaces (mgt0, pkt0, pkt1, pkt2, pkt3) mapped through network configuration
- Two SBC SWe Edge instances ESXi host with
- Software Requirement
- HA supported version is installed on the system, for example, release 12.1.
Ethernet Interface Requirements
Hide ATTENTIONAttention: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there.
Multiexcerpt | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
|
Workflow
Step | Action |
---|---|
1 | Deploy Enabling High Availability on an SBC Active and Standby SWe Edge Instances |
2 | Deploy Verifying High Availability on an SBC SWe EdgeStatus |
Enabling High Availability on Active and Standby SWe Edge Instances
Anchor | ||||
---|---|---|---|---|
|
Enable HA on the Active and Standby SWe Edge instances to increase the stability of the system during mid-call failovers.
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there. |
Multiexcerpt | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Start
|
Verifying High Availability Status
Anchor | ||||
---|---|---|---|---|
|
Verify the HA pair status to ensure that both the Active and the Standby SBC SWe Edge instances are properly enabled.
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there. |
Multiexcerpt | ||
---|---|---|
| ||
Start
|