Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to Installing SBC 5400 Hardware

Back to Rack Mounting the SBC 5400 Chassis

Panel

In this section:

Table of Contents
maxLevel2
minLevel2

 

This section provides details for mounting

Spacevars
0model5
chassis in a 23-inch four-post rack.

Installing 23 Inch Rack Adaptors

Align the bottom of the 23-inch Rack Adaptor with the mark on the front rail of the rack, ensuring the self-clinching nuts are protruding inside the rack and secure it with (2) #10-32X5/8" Cup Head screws at the top-most and at the bottom-most racking slots. Repeat the same procedure for the remaining Rack Adaptors.

Note

For racks with #12-24, open square, or open round holes, slide the #10-32 U-Nut over the rail and align the concentric with top-most and bottom-most mounting holes with nut portion protruding from inside surface of rail.

Installing Rack Rail Guides and Rack Rear Supports

Note

The Rack Rail Guides and Rack Rear Supports are universal and can be installed either on the left or the right side of the rack.

  1. Align the bottom of the Rack Rail Guide with the bottom of the 23-inch Rack Adaptor and secure loosely with (2) #10-32X5/8" Cup Head screws at the top-most and at the bottom-most racking slots. Repeat the same procedure for the opposite side.
  2. Align the bottom of the Rack Rear Support with the bottom of the 23-inch Rack Adaptor, making sure that the Rack Rear Supports remain outside the Rack Rail Guides and secure it loosely with (2) #10-32X5/8" Cup Head screws at the top-most and at the bottom-most racking slots. Repeat the same procedure for the opposite side.
  3. Secure the Rack Rear Support to Rack Rail Guide using (4) #8-32X1/4" Truss Head screws, utilizing the forward-most and rear-most integrated nut locations in the Rack Rail Guide available within the slots in Rack Rear Supports. Repeat the same procedure for the opposite side.
  4. Finish securing the Rack Mount Brackets and Rack Rear Supports to the 23” Rack Adaptors by tightening the (8) #10-32X5/8" Cup Head screws.

Installing Chassis into the Slide Rack Assembly

Warning

Due to the size and weight of the system, never attempt to install the system by yourself.

  1. Lift the system to align the Chassis Rails with the Rack Rail Guides and slide the chassis into the Rack Rail Guides ensuring that each Chassis Rail is engaged in its respective Rack Rail Guide.
  2. Push the Chassis fully into Rack Rail Guides until the Chassis Rack Ears are in full contact with the front surface of the Rack Rail Guides.
  3. Secure the Chassis with (4) #10-32 X5/8" Cup Head screws at the top-most and at the bottom-most racking slots in the Chassis Rack Ear.

Pagebreak

Caption
0Figure
123 inch 4-Post Rack Diagram

Image Modified


Pagebreak