...
Panel |
---|
...
borderColor | green |
---|---|
bgColor | transparent |
borderWidth | 2 |
...
Back to Rack Mounting the SBC 5400 Chassis
In this section:
|
This section provides details for mounting
Spacevars | ||
---|---|---|
|
Align the bottom of the 23 inch Rack Adaptor with the mark on front rail of the rack, ensuring the self-clinching nuts are protruding inside the rack and secure it with (2) #10-32X5/8" Cup Head screws at the top-most and at the bottom-most racking slots. Repeat the same procedure for the remaining Rack Adaptors.
Note |
---|
...
For racks with #12-24 with open square or with open round holes, slide #10-32 U-Nut over rail and align concentric with the top-most and the bottom-most mounting holes with nut portion protruding from inside surface of rail. |
Align the bottom of the Rack Mount Bracket with the bottom of the Rack Adaptor and secure loosely with (2) #10-32X5/8" Cup Head screws at the top-most and at the bottom-most racking slots. Repeat the same procedure for rear Rack Mount Bracket and the opposite side.
Note |
---|
The Rack Rail Guides are universal and can be installed either on the left or on the right side of the rack. |
Position Rack Rail Guide by centering the center-line etched in the Rack Rail Guide in the center of the rack and secure with (4) #8-32X1/4" Truss Head screws through each Rack Mount Bracket, repeat for the opposite side. Finish securing the Rack Mount Brackets to the rack by tightening the (8) #10-32X5/8" Cup Head screws.
Follow these steps to install 23 inch rack with 2 posts Chassis to Slide Rack Assembly:
Warning |
---|
Due to the size and weight of the system, never attempt to install the system by yourself. |
Caption | ||||
---|---|---|---|---|
| ||||
Pagebreak |
---|