Page History

Name

The name of this access control list rule.

Precedence

Use this parameter to specify the rule precedence (e.g. when the rule is loaded and executed over other rules for each incoming packet)to control which ACL rule is applied when multiple rules match a given packet. If an incoming packet matches two identical multiple rules, then the IP ACL rule with the highest precedence (lowest numerical precedence value) is applied for to that incoming packet.

Each IP ACL rule must use a unique precedence value.

Protocol

Enter IP protocol type for use as a criterion of the IP input match. Choices are 0-255, or one of the following:

• any – (default) filter all protocols
• icmp – filter ICMP only
• icmpv6 – filter ICMPv6 only
• ospf – filter OSPF only
• tcp – filter TCP only
• udp – filter UDP only 

These protocols are typically associated with particular logical port values.

IP Interface
Group

The name of a IP interface group to match or "any" to match any IP interface group.

IP Interface

The name of an IP interface to match, or "any" to match any IP interface.

Mgmt IP Interface Group

The name of an management a Management Interface Group.

NOTE: The Mgmt IP Interface Group parameter is only available from the Default Address Context, even if the Default Address Context does not contain any other configurations.

Mgmt IP Interface

The name of an management IP Interfacea Management IP Interface.

NOTE: The Mgmt IP Interface parameter is only available from the Default Address Context, even if the Default Address Context does not contain any other configurations.

Source IP Address

The source IP address to match.

Source Address
Prefix Length

The length of source IP address prefix which must match the protocol. Must be 0 -
32, default is 0.

Destination IP Address

The destination IP address (IPV4/IPV6) prefix to match.

Source Port

The IP port value. Must be 0 - 65535, default is any.

Destination
Port

The IP port value. Must be 0 - 65535, default is any.

Action

The action to be taken when the IP access control list rule match.

• Accept
• Discard

Fill Rate

The number of packets to add to the bucket credit balance (in packets/second). If a packet is received at a rate exceeding this fill rate, it is discarded subjected to the discard rate set in the IP Policing Alarm profile or in the Policer Alarm monitoring this Media Port. The bucket credit balance is always less than the configured bucket size regardless of the size of this increment.

Must be 1 - 10000, default is 50.

Bucket Size

The policing bucket size (in packets). It represents a credit balance that should be consumed before the packets are discarded. The consumed credits reside in the bucket and gets reduced for every packet received on the Network Interface (NI). If a packet is received when the credit balance is less than the size of the packet, the packet is discarded subjected to the discard rate set in the IP Policing Alarm profile or in the Policer Alarm monitoring this Media Port. (default is 'unlimited', which allows continuous policing). Must be 2048-65520, default is 50.

State

It specifies the administrative state of ACL rule.

• enabled
• disabled (default)