Versions Compared

Old Version 3

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Panel

In this section:

Table of Contents
maxLevel2



Info
iconfalse

Related articles:

Children Display



Excerpt

The Signaling QoS KPI Profile is associated with an IP Signaling Profile that you in turn can associate to an IP Peer, IP Signaling Peer Group or Trunk Group as a part of an IP Signaling Profile.

To View IP Signaling Peer Group

On the SBC main screen, go to Configuration > System Provisioning > Category: Call Routing > Profiles > IP Signaling Peer Group. The IP Signaling Peer Group window is displayed.

Image Added

To Edit IP Signaling Peer Group

To edit any of the IP Signaling Peer Group in the list, click the radio button next to the specific IP Signaling Peer Group name.

The Edit Selected IP Signaling Peer Group window is displayed below.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create IP Signaling Peer Group

To create a new IP Signaling Peer Group, click New IP Signaling Peer Group tab on the IP Signaling Peer Group List panel.

The Create New IP Signaling Peer Group window is displayed.

Create IP Signaling Peer Group Create Window

Image Added


IP Signaling Peer Group Parameters:

Parameter

Description

Name

The name of the IP Signaling Peer Group.

Length: Up to 23 characters

Description

A short description of this IP Signaling Peer Group.

Length: Up to 99 characters

Send All IP Address And FQDN

Choose whether or not to send all the IP Addresses and the FQDNs using this IP Signaling Peer Group.

  • Disable (default)
  • Enable
IP Signaling Peer Group Data

Sequence

Specifies the sequence of this IP Signaling Peer Group.

Service Status

Specifies the type of service for this IP Signaling Peer Group. Select In Service to use this IP peer.

  • In Service
  • Out Of Service (default)

IP Address V4 or V6

Specify the IP Address of this IP Signaling Peer Group.

IP Port

Specify the TCP/UDP port value of this IP Signaling Peer Group.

FQDN

Specify the FQDN value to use for sending egress calls/requests to the IP peer.

FQDN Port

Specify the FQDN port number to be used for sending egress calls/requests to the  IP peer.

To Delete IP Signaling Peer Group

To delete an IP Signaling Peer Group, click the "x" button next to the specific IP Signaling Peer Group.

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Click Yes to remove the specific IP Signaling Peer Group from the list.