Page History
...
Configuring the ASM Network Settings with DHCPv4 Disabled
Info |
---|
ASM configuration is also completed under Tasks > Lync™ Survivable Branch Appliance > Setup SBA> ASM Config. |
If you wish to statically define the IP address of the ASM, follow these instructions:
...
Note | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
The IP address assigned by the DHCP server must be on the same subnet as
If there is no DHCP server answering requests, a 169 addressing scheme is assigned to the ASM after a timeout period. | ||||||||||||||||
Info | ||||||||||||||||
ASM configuration is also completed under Tasks > Lync™ Survivable Branch Appliance > Setup SBA> ASM Config. |
Enable DHCP:
- In the WebUI, click the Settings tab.
In the left navigation pane, go to Application Solution Module > ASM Configuration. For field definitions, see ASM Configuration - Field Definitions.
The example below shows DHCP disabled for IPv4 on Network Adapter 1 and enabled for IPv4 on Network Adapter 2.
Network Adapter 1 ASM Configuration - DHCP EnabledFrom DHCPv4 Enabled, select Yes. Depending on the IP Addressing mode selected, IPv4 and/or IPv6 options are displayed. See below:
DHCPv4 Enabled, Configuration Options
Network Adapter 1DHCPv4 Enabled IP Addressing Mode Configuration Options Available Yes IPv4 None Yes IPv4 and IPv6 IPv6 Configuration
Network Adapter 2DHCPv4 Enabled IP Addressing Mode Configuration Options Available Yes IPv6 IPv6 Configuration Yes IPv4 None Yes IPv4 and IPv6 IPv6 Configuration - Update configuration (see Network Adapter 1 Configuration - Field Definitions and Network Adapter 2 Configuration - Field Definitions.
- Click Apply.
...