Use this object to specify the the Packet Outage window to set packet outage detection parameters for this a specified SIP trunk group.
To View and Edit Packet Outage Parameters
On the
main screen, go to
Configuration >
System Provisioning >
Category: Trunk Provisioning >
Trunk Group >
Sip SIP Trunk Group >
Sip SIP Trunk Advanced >
Packet Outage. The Packet Outage window is displayed. orAll > Address Context > Zone > SIP Trunk Group > Packet OutageThe Packet Outage can be checked for each Address Context, for each Zone, for each Sip Trunk Group created or for all the Address Contexts, Zones and Sip Trunk Groups created. Use the drop-down box boxes to select the desired specific Address Context, Zone and Sip SIP Trunk Group you want to configure.
The Edit Packet Outage window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Sip SIP Trunk Advanced Group - Packet Outage Edit Window |
|---|
|
|
The following fields are displayed:Use the following table to change the values as needed and then click Save.
| Caption |
|---|
| 0 | Table |
|---|
| 1 | H323 SIP Trunk Advanced Group - Packet Outage Parameters |
|---|
|
Parameter
|
Description
|
|---|
| Minimum Duration | Specifies Specify the minimum period of outage for a call, in milliseconds, for that call to be counted as part of by the packet outage detection algorithm. Must be in the range 0-65535, default is 6000 (milliseconds). | | Minimum Calls | Specifies, for the current interval, the Specify the minimum number of calls with outages that are required in an interval to declare a packet outage event. Must be in the range 0-65535, default is 1000 (calls). | | Bandwidth Limit Reduction | Specifies Specify the amount to reduce the bandwidth limit (as a percentage of the configured limit) when a packet outage is detected. Must be in the range 0-100, default is 50 (percent). | Detection State | Specifies the administrative state of packet outage detection: enabled—automatic bandwidth reduction will occur Specify whether to enable automatic bandwidth reduction when a packet outage event is detected .: disabled Disabled (default) —packet – packet outages are not detected and the maximum bandwidth limit is restoredis not adjusted.- Enabled – automatic bandwidth reduction occurs when a packet outage is detected.
| Detection Interval | Specifies Specify the length of time interval, in minutes, for detecting in which to count packet outages via the to compare against the Minimum Calls threshold before triggering a packet outage detection algorithmevent. Must be in the range 5-1440, default is 15 (minutes). |
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
Packet Outage Commands
To clear all the Trunk Group Packet detection, choose packet outage detection state for a trunk group, select Clear in the Commands drop- down box list and click Select.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Sip Trunk Advanced - Packet Outage Commands |
|---|
|
|
A pop-up window appears seeking your confirmation. Click Clear.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | SIP Trunk Advanced - Packet Outage Command Confirm |
|---|
|
Image Removed |
A confirmation message appears with the result of this action.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | SIP Trunk Advanced - Packet outage Reason |
|---|
|
Image Removed |
Click OK to complete the process and exitConfirm that you want to clear the packet outage detection state when prompted.