Page History

...

1. In the WebUI, click the Settings tab.
2. In the left navigation page, access SIP > SIP Profiles.

3. Click the ( ) icon at the top of left corner and add a new SIP profile.

4. Configure the parameters as shown below (example values are shown in the table; configure as per your network requirements). For details on field descriptions, refer to Creating and Modifying SIP Profiles.

5. Leave all other parameters as default.

6. Click OK.

   Caption
   0 Table 1 SIP Profile Configuration - Example Values
   Parameter Example Value Description Teams Direct Routing Profile FQDN in From Header SBC Edge FQDN FQDN In Contact Header SBC FQDN NOTE: For Microsoft Teams, the Signaling Group facing the Teams server must be configured as SBC Edge FQDN or Static (if there is more than one signaling group connected to Teams Direct Routing). The FQDN in Contact Header should be the same FQDN used in Office 365 Tenant Online Gateway. If the IP Address of the SBC is configured in the Contact Header instead of the FQDN of the SBC, a Forbidden message is received. NOTE: If you set this field to Static and you expect the port number of the Contact header in the outbound SIP messages, you must configure the Static Host FQDN/IP field with the Listen Port number of the SIP signaling group. Origin Field Username <FQDN of SBC> (in the example aepsite6.SonusMS01.com)

   Available_sinceTypeModified ForRelease8.0.2 

   Pagebreak

   Caption
   0 Figure 1 SIP Profile - Example

...

1. In the WebUI, click the Settings tab.
2. In the left navigation page, access SIP > SIP Profiles.

3. Click the ( ) icon at the top of left corner and add a new SIP profile.

4. Configure the parameters as shown below (example values are shown in the table; configure as per your network requirements). For details on field descriptions, refer to Creating and Modifying SIP Profiles.

5. Leave all other parameters as default.

6. Click OK.

   Caption
   0 Table 1 SIP Profile Configuration - Example Values
   Parameter Example Value Description SIP Trunk Profile FQDN in From Header Disable FQDN In Contact Header Disable NOTE: If you set this field to Static and you expect the port number of the Contact header in the outbound SIP messages, you must configure the Static Host FQDN/IP field with the Listen Port number of the SIP signaling group. Origin Field Username SBC

   Available_since
   Type Modified For Release 8.0.2

    

   Caption
   0 Figure 1 SIP Profile - Example

...