This window displays SBC Daughter Board (DB) module status detailsUse the Daughter Board Status window to view the status of SBC Daughter Board modules in SBC 5xxx and SBC 7000 systems.
On the
main screen, go to
Monitoring >
System >
Category: Hardware Status >
Daughter Board Status. Status orAll > System > Daughter Board StatusThe Daughter Board Status window is displayedopens.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Daughter Board Status |
|---|
|
 Image Added |
Image Removed
The following fields are output is displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | system daughterBoardStatus Parameters |
|---|
| | Daughter Board Status Parameters |
|
Parameter | Description |
|---|
| Server Name | Server name. | | Slot | Specifies the slot associated with the |
|
...
...
| ID | Daughter board identifier. :- SPS100 – SBC 5x00 SPS100 module
- DB0 – SBC 5x00 SPS100DB 0 module
- DB1 – SBC 5x00 SPS100DB 1 module
- DSP20 – SBC 5x10 DSP20 module
- DSP25 – SBC 5x10 DSP25 module
:
|
|
...
- – SBC 7000 DSP-LC slot 1
FRU_DSP2 – SBC 7000 DSP-LC slot 2 FRU_DSP3 – SBC 7000 DSP-LC slot 3 FRU_DSP4 – SBC 7000 DSP-LC slot 4
| | Present | Indicates if the module is present (True or |
|
...
| False). | | Product Name | Identifies manufacturer module name (if present). | | Serial Num | Identifies the serial number of the module (if present). |
|
| Note |
|---|
The maintenance fields Image Load Failure Count and Fpga Version |
| Operational Status | Operational state of daughter board. |
|
...
- Disabled – Card is disabled.
|
|
...
- Dryup – Card is enabled but in the process of drying up. Once completed, card will be set to ‘disabled’.
|
|
...
- Enabled – Card is enabled.
|
|
...
- Failed – If a DSP2x or DSP-LC module fails to boot over three consecutive tries (typically due to a hardware failure), it is taken out of service and marked as state “failed”. The rest of the system continues to boot normally, including any other DSP modules. The module failure is logged/alarmed with trap “sonusConnexIpSystemCESlotFailedNotification”. The slot remains in the failed state until the module is disabled and re-enabled once a replacement card is installed.
|
|
...
- Loading – Card is enabled but in the process of booting. Resources are not yet available. Once completed, card will be set to ‘enabled’.
|
|
...
...
...
| NOTE: For 5x00 systems, only the |
|
...
| Enabled state displays in the results. | | Image Load Failure Count |
|
...
Number of module boot failures since the last successful module boot, for use during diagnostic testing of a potentially failed module. NOTE: This maintenance field does not apply to SPS100 cards. | | Fpga |
|
...
| Version | A card’s programmed firmware version (using the FPGA build date). NOTE: This maintenance field does not apply to SPS100 cards. |
|
By default only ten entries are displayed in a view. You can choose the number of entries to be displayed under the Show entries drop down box.