Page History
| Panel | ||||
|---|---|---|---|---|
In this section:
|
| Info | ||
|---|---|---|
| ||
Related articles:
|
Overview
...
When enabled in the
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
- IP Address
- IP Netmask
- IP Broadcast Address
The DHCP client also dynamically configures several node-level attributes. Upon configuration of these attributes, any existing configuration is removed.
- Default Route
- DNS Server(s)
- NTP Server(s)
- Domain Name
| Note | ||||||
|---|---|---|---|---|---|---|
|
...
...
Although enabling DHCP on multiple interfaces is supported, the recommendation is to enable only one interface with DHCP, or unexpected results may occur. If using multiple interfaces, you should assign the additional IP addresses via static configuration. |
| Note |
|---|
In case of IP lease renew for DHCP, or change of static IP where the new IP address is different, the existing calls will be disconnected. |
| Pagebreak |
|---|
Prerequisites - Setting up the DHCP client
In order to use the DHCP client on your network, the DHCP server must be on the network.
Using DHCP for System Access During Initial Configuration
When a system is in Factory Default mode, the DHCP client is enabled on Ethernet 1 and the DHCP server is enabled on Ethernet 2. This allows you to connect to the
...
| Spacevars | ||
|---|---|---|
|
The DHCP client acquires an IP address from DHCP server. During DHCP lease acquisition, the
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
This default configuration is present only until initial configuration is complete. Following that, you can configure any desired DHCP functionality. The default IP addresses assigned before initial configuration are as follows:
...
SBC 2000 only:
Admin Port - Default address of 192.168.128.2. You can statically assign the PC an address in the 192.168.128.x subnet (i.e.,. 192.168.128.8) to connect to the
...
.Spacevars 0 series2
...
- SBC 2000 and
...
- SBC 1000:
- Ethernet 1 – Acquires an address via a connected DHCP server.
- Ethernet 2 – Default address of 192.168.129.2. You can either statically assign an address to the PC in the 192.168.129.x subnet (e.g. 192.168.129.8) or the
...
's DHCP server will assign one (192.168.129.3).Spacevars 0 longproduct
How a DHCP Client works - Example Scenario
The DHCP client can be configured on any interface in any network layout as along as there is a DHCP server. For example, in a typical
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Spacevars | ||
|---|---|---|
|
...
| Caption | ||||
|---|---|---|---|---|
|
...
|
...
|
| Pagebreak |
|---|
Overview
Content Tools