Applicability
Tip |
---|
SBC 1000/2000 Edge version 3.0 or later. |
Summary
...
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Signaling/Media Source IP - Auto |
---|
| Image Modified |
|
...
In a call from the phone to SIP Server 10.3.1.253:
...
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Calls With Signaling/Media Set to Specific Ethernet/IP Interface |
---|
| Image Modified |
|
In a call from the phone to SIP Server 50.2.2.201:
...
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Calls to SIP Server - Not on Specified Signaling/Media Interface |
---|
| Image Modified |
|
In a call from the phone to SIP Server 10.3.1.253:
...
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Setting NAT Public IP Address |
---|
| Image Modified |
|
...
In a call from the phone to SIP Server 50.2.2.201:
- The call route specifies the Network 2 SG Destination Signaling Group.
- The Network 2 SG Signaling Group specifies that calls be sent to the destination server configured in the Network 2 SIP Servers Table.
- The Network 2 SIP Server Table specifies the SIP Server IP 50.2.2.201.
- With the Network SG 2's Signaling/Media Source IP configured to Auto , the IP Routing Table is consulted to ensure there is an IP route to the 50.2.2.0/24 network.
- The INVITE is sent out Ethernet 3 to the SIP Server with the Source IP address of SBC's Ethernet/IP port 3.
- The SIP and SDP IP addresses are set to 50.4.4.155 because NAT Public IP is configured in the egress Signaling Group.