Page History
...
Add_workflow_for_techpubs | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Panel | ||||
---|---|---|---|---|
In this section:
|
...
Field | Description | |||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Modem Passthrough | Specifies whether or not modem passthrough is enabled when using the G.711 codec. If you wish to support modem calls, enable this option. When Disabled, the
| |||||||||||||||||||||||||||||||||
Fax Passthrough | Controls whether or not the
| |||||||||||||||||||||||||||||||||
CNG Tone Detection | Specifies whether or not the
| |||||||||||||||||||||||||||||||||
Fax Tone Detection |
Specifies whether or not the
| |||||||||||||||||||||||||||||||||
DTMF Signal to Noise | Sets the Signal to Noise Ratio that affects DTMF detection. Setting higher Signal-to-Noise ratio values reduces the chance of false detection; however, a setting can be too high for the amount of noise in an audio stream. Use this field to set a value in the range -3 dB to +6 dB. The default value for the field is 0 dBM.
| |||||||||||||||||||||||||||||||||
DTMF Minimum Level | Sets the minimum signal level for DTMF detection; DTMF digits lower than the minimum are not detected. Valid entries: -48 to -14 dBm0. The default value of the field is -38 dBm0.
|
...