...
Warning |
---|
You must reconfigure snmpv3 before enabling FIPs mode. Failure to do so could cause the SBC to crash due to excessive trap generation. Perform the following steps to reconfigure snmpv3: |
All trap targets with authPriv/authNoPriv securityLevel must be disabled. Example:
Code Block |
---|
admin@sbc1% show oam snmp trapTarget EMS_-10.54.71.176
ipAddress 10.54.71.176;
port 162;
trapType v3;
targetUsername emstrapuser;
targetSecurityLevel authPriv;
state enabled;
admin@sbc1% set oam snmp trapTarget EMS_-10.54.71.176 state disabled
admin@sbc1% commit |
The
Spacevars | ||
---|---|---|
|
...
Spacevars | ||
---|---|---|
|
FIPS compliant operating mode is a mode of system operation that is fully compliant with FIPS-140-2 at security level 1+. Putting the system in FIPS-140-2 operating mode requires enabling the fips-140-2 mode
parameter as well as configuring other parameters.
...
Parameter | Description | ||
---|---|---|---|
Mode
|
The options are:
|
Code Block |
---|
admin@sbc1% set oam snmp users emstrapuser authKey Xd:aa:1f:09:75:6e:f6:da:NN:NN:NN:NN:NN:0d
admin@sbc1% set oam snmp users emstrapuser privKey Xd:aa:1f:09:75:6e:f6:da:NN:NN:NN:NN:NN:0d
admin@sbc1% commit |
2. Enable authPriv/authNoPriv trap targets:
Code Block |
---|
admin@sbc1% set oam snmp trapTarget <trap_target_IP> state enabled |