Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel

In this section:

Table of Contents
maxLevel2


The 

Spacevars
0series4
 supports configuring up to 14 alternate media addresses using the parameter Alt Media IP Addresses when configuring IP interfaces. Any A maximum of 254 IP addresses are configurable on each LIF for IPv4 and/or IPv6 addresses. Any combination of IPv4/IPv6 is allowed and applies to all supported protocols (SIP, H.323, GW-GW).

...

Alternate Media IP’s are chosen based on Round Robin method (e.g. the first call uses the primary IP and port, the second call uses the first configured alternate Media IP and port, the third call uses the second configured alternate Media IP, etc.). Each alternate Media IP must be unique across all interfaces in the same addressContext. However, the IPs may overlap between SIP, H.323 or Gateway signaling addresses in the same Address Context.

A maximum of 254 IP addresses are configurable on each LIF for IPv4 and/or IPv6 addresses.
Info
titleNote
  • The SBC 7000 series system supports 8,192 IP addresses.
  • The SBC 5xx0 series system supports 4,096 IP addresses.
  • The SBC SWe supports 2,048 IP addresses.

...

To View Alt Media IP Addresses

On the SBC main screen, navigate to All > Address Context > IP Interface Group > IP Interface > Alt Media IP Addresses.

...

Caption
0Table
1Alt Media IP Addresses Parameters


Parameter

Description

Alt Media IP Addresses

Use this parameter to specify up to

...

254 additional IPv4 and/or IPv6 media IP addresses on this IP interface. Any combination of IPv4 and IPv6 is allowed. The following rules apply when configuring alternate media IP addresses:

  • An IPv4/IPv6 alternate media IP address is only allowed if an IPv4/IPv6 address is defined in the primary or alternate (main) address.
  • An alternate media IP address must be in the same network as the primary media address (of the same IP version). Hence, CPX needs to determine the subnet based on the primary/alt IP address and primary/alt prefix, and then verify that the given alternate media address is on the same subnet.
  • An alternate media IP address may be added while the IP interface is enabled and in-service. However, the IP can only be deleted when the IP interface state is set to "disabled"

...

Spacevars
0series2

...

  • .



To Delete Alt Media IP Addresses

...