Page History
...
| Panel |
|---|
...
| borderColor | green |
|---|---|
| bgColor | transparent |
| borderWidth | 2 |
...
| Noprint |
|---|
In this section:
|
...
...
| Info | ||
|---|---|---|
| ||
For PCSI LI configuration, refer to Configuring the SBC for Lawful Interception as it is supported only on the D-SBC. |
Configuring the Call Data Channel
To configure PCSI LI:
...
...
...
| Anchor | ||||
|---|---|---|---|---|
|
As user 'Calea', use the following commands to configure LI:
| Code Block | ||
|---|---|---|
| ||
% set addressContext <default> intercept
nodeNumber <integer> |
| Include Page | ||||
|---|---|---|---|---|
|
| Anchor | ||||
|---|---|---|---|---|
|
| Code Block |
|---|
### create and configure IKE and IPsec protection profiles
set profiles security ipsecProtectionProfile PRGGSX2_IPSEC_PROT_PROF saLifetimeTime 28800
set profiles security ipsecProtectionProfile PRGGSX2_IPSEC_PROT_PROF espAlgorithms integrity hmacSha1,hmacMd5
set profiles security ipsecProtectionProfile PRGGSX2_IPSEC_PROT_PROF espAlgorithms encryption aesCbc128,_3DesCbc
set profiles security ikeProtectionProfile PRGGSX2_IKE_PROT_PROF saLifetimeTime 28800
set profiles security ikeProtectionProfile PRGGSX2_IKE_PROT_PROF algorithms encryption aesCbc128,_3DesCbc
set profiles security ikeProtectionProfile PRGGSX2_IKE_PROT_PROF algorithms integrity hmacSha1,hmacMd5
set profiles security ikeProtectionProfile PRGGSX2_IKE_PROT_PROF dpdInterval noDpd
### create IKE peer
set addressContext default ipsec peer PRGGSX2 ipAddress 10.220.11.8 preSharedKey 00000000000000000000000000000000 localIdentity type ipV4Addr ipAddress 10.220.41.161
set addressContext default ipsec peer PRGGSX2 remoteIdentity type ipV4Addr ipAddress 10.220.11.22
set addressContext default ipsec peer PRGGSX2 protocol ikev1 protectionProfile PRGGSX2_IKE_PROT_PROF
### create an SPD rule for this IKE peer
set addressContext default ipsec spd PRGGSX2_SPD state enabled precedence 1001
set addressContext default ipsec spd PRGGSX2_SPD localIpAddr 10.220.41.161 localIpPrefixLen 32 remoteIpAddr 10.220.11.22 remoteIpPrefixLen 32
set addressContext default ipsec spd PRGGSX2_SPD action protect
set addressContext default ipsec spd PRGGSX2_SPD protocol 0
set addressContext default ipsec spd PRGGSX2_SPD protectionProfile PRGGSX2_IPSEC_PROT_PROF
set addressContext default ipsec spd PRGGSX2_SPD mode transport
set addressContext default ipsec spd PRGGSX2_SPD peer PRGGSX2
### enable IPsec on the IP interface group
set addressContext default ipInterfaceGroup LIG1 enabled |
| Anchor | ||||
|---|---|---|---|---|
|
To configure the IP Interface Group, execute the following command:
| Code Block | ||
|---|---|---|
|
...
set addressContext default intercept callDataChannel CDC ipInterfaceGroupName LIG1 commit |
| Anchor | ||||
|---|---|---|---|---|
|
For other options of configuring the intercept flavor as IMS LI, refer to the section Configuring SBC For Lawful Interception.
| Code Block |
|---|
set addressContext default intercept callDataChannel CDC interceptStandard packetCable vendorId ss8
commit |
| Anchor | ||||
|---|---|---|---|---|
|
...
| Note |
|---|
The PCSI LI supports configuring up to 8 mediation servers under the CDC. |
| Code Block | ||
|---|---|---|
|
...
set addressContext default intercept callDataChannel CDC interceptStandard |
...
|
...
mediationServer MS1 commit |
| Anchor | ||||
|---|---|---|---|---|
|
...
CDC for Media Interception over TCP
| Code Block | ||
|---|---|---|
|
...
set addressContext default intercept callDataChannel CDC mediationServer MS1 media tcp ipAddress fc22:3200::230:7 portNumber 8765 dscpValue 0 commit |
...
set addressContext default intercept callDataChannel CDC mediationServer MS1 media tcp mode inService state enabled commit |
| Anchor | ||||
|---|---|---|---|---|
|
...
| Code Block |
|---|
...
...
set addressContext default intercept callDataChannel CDC rtcpInterception enabled commit |
Viewing PCSI LI Configuration
Enter the show commands to view the configurations.
| Anchor | ||||
|---|---|---|---|---|
|
To view the intercept details, execute the following command:
| Code Block |
|---|
> show status addressContext default intercept callDataChannel
callDataChannel CDC {
mediationServerMediaStatus MS1 {
tcpChannelstatus inService;
tcpPacketsSent 0;
tcpPacketsLost 0;
udpPacketsSent 0;
udpPacketsLost 0;
}
}
[ok] |
| Anchor | ||||
|---|---|---|---|---|
|
To view the CDC configuration, execute the following command:
| Code Block |
|---|
...
show addressContext default intercept callDataChannel CDC
interceptStandard packetcable;
vendorId ss8;
ipInterfaceGroupName LIG1;
mediationServer MS1 {
media {
tcp {
ipAddress 10.54.6.1;
portNumber 8765;
dscpValue 0;
mode inService;
state enabled;
}
}
}
[ok] |
| Pagebreak |
|---|
Overview
Content Tools