Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: rebranding

For CODEC G711SS, specifies whether Use the Silence Insertion Descriptor window to define the Silence Insertion Descriptor (SID) packets are sent during a call.

To View and Edit Silence Insertion Descriptor

attributes for a Packet Service Profile. These settings apply if sending SID packets is enabled in the codec entry (must be using the G711ss codec).

On the On SBC main screen, go to Configuration > Profile Management > Category: Media Profiles > Packet Service Profile >Silence Insertion Descriptor or
Configuration > System Provisioning > Call Routing > Profiles >  Packet Service Profile > Silence Insertion Descriptor or
Configuration > System Provisioning > Trunk Provisioning > Packet Service Profile > Silence Insertion Descriptor or
All > Profiles > Media > Packet Service Profile > Silence Insertion Descriptor.

The Silence Insertion Descriptor window opens. Select a Select the desired Packet Service Profile from the drop-down list to view and edit its respective Silence Insertion Descriptor parameters.The Silence Insertion Descriptor window is displayed.

Caption
0Figure
1Profile Management - Media Profiles - Packet Service Profile - Silence Insertion Descriptor

The following fields are displayed:Use the following table to edit the SID parameters and then click Save.

Caption
0Table
1Silence Insertion Descriptor Parameters

Parameter

Description

G711Sid RTP Rtp Payload Type

Specifies the G.711 Silence Insertion Descriptor ( SID ) RTP payload type, in the range of 0 to 127. This applies only if the preferred audio encoding codec is G.711 with Silence Suppression.
The default value is 19, which is Sonus

Spacevars
0company
-proprietary comfort noise.
The other possible value is 13, which is standard RFC 3389 comfort noise.

Heartbeat• enabled—send

Specifies whether to enable sending SID packets within a minimal interval during silence intervals to provide an estimate of the background noise to the receiving end.
• disabled (default)—Do not send SID packets, placing the burden on the remote side to determine the way it will generate comfort noise.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

a silence period (at least one SID packet must be sent within a SID maximum packet time frame). Options are:

• Enable (default)
• Disable

Pagebreak