Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to CLI Configure Mode

Back to Profiles - CLI

Panel

In this section:

Table of Contents
maxLevel2

 

Use the IP Signaling Peer Group object to configure an IP Signaling Peer Group containing a set of IP peers.

Command Syntax

Code Block
languagenone
 % set profiles ipSignalingPeerGroup <peer_group_name>
 	description <string>
 	ipSignalingPeerGroupData <0-32000>
 	sendAllIpAddressAndFQDN <disable | enable>

Command Parameters

The IP Signaling Peer Group Parameters are as shown below

Caption
0Table
1IP Signaling Peer Group Parameters

Parameter

Length/Range

Description

ipSignalingPeerGroup

1-23

Name of IP Signaling Peer Group.

description

1-199

IP Signaling Peer Group description.

ipSignalingPeerGroupData

N/A

IP Signaling Peer Group configuration details. Assign a sequence number to each IP Peer to include in this IP Signaling Peer Group.

  • <sequence#> – A unique sequence number for each IP Peer belonging to this IP Signaling Peer Group. (range: 0-32000). For each IP Peer, the following configuration options are available:
    • fqdn – FQDN to use for sending egress calls/requests to this IP peer. (up to 63 characters)
    • fqdnPort – Port number for FQDN. (range: 0-65535 / default = 0)
    • ipAddress – IP address of this IP peer. (default is "0.0.0.0")
    • ipPort – TCP/UDP port for this IP peer. (range: 0-65535 / default = 0)
    • serviceStatus – Select "inService" to use this IP peer.
      • inService
      • outOfService (default)

sendAllIpAddressAndFQDN

N/A

By default, the PSX sends one IP address to the SBC in round robin order. Enable this flag to send all IP addresses and FQDNs for the IP Signaling Peer Group in a single policy response.

  • disable (default)
  • enable

Command Example

Code Block
languagenone
% set profiles ipSignalingPeerGroup SIPPeer-1 description "Peer group example" ipSignalingPeerGroupData 1 fqdn www.mysite.com fqdnPort 5066 ipAddress 10.22.33.44 serviceStatus inService  
% set profiles ipSignalingPeerGroup SIPPeer-1 sendAllIpAddressAndFQDN enable 
% show profiles ipSignalingPeerGroup  
sendAllIpAddressAndFQDN enable;  
ipSignalingPeerGroup SIPPeer-1 {  
	description "Peer group example";  
	ipSignalingPeerGroupData 1 {  
		serviceStatus inService;  
		ipAddress 10.22.33.44;  
		fqdn www.mysite.com;  
		fqdnPort 5066;  
	}  
} 

Pagebreak