...
...
...
...
Back to Table of Contents
Back to All
Back to All - Profiles
Back to Profiles - Media
Back to Media - Tone And Announcement Profile
Back to Media - Tone And Announcement Profile - Local Ring Back Tone
Use this window to enable or disable flags that specify local ringback tone behavior within a selected Tone and Announcement Profile
...
.
To View and Edit Flags
On the SBC main screen,
...
navigate to All > Profiles > Media > Tone And Announcement Profile > Local Ring Back Tone > Flags.
Select the desired Tone And Announcement Profile from the drop-down list to view its respective Flags parameters.
The Flags window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Media Profiles - Local Ring Back Tone - Flags |
|---|
|
 Image Modified
|
| Info |
|---|
|
To view the flag Annoucement Based Tones, the option Signaling Tone Package State must be enabled in Local Ring Back Tone. |
The following fields are displayed:
...
...
| Specifies Lrbt state of the Egress: |
|
...
| | Use This Lrbt For Ingress | Specifies Lrbt state of the Ingress: | | Dynamic LRBT | Use this flag to play tone locally on receipt of 180 with SDP, until RTP is received from the remote peer. | | Force LRBT | Use this flag to play tone locally on receipt of any 18x with or without SDP, until 200 OK (INVITE) or UPDATE is received from the remote peer. | | Announcement Based Tones | Use this flag to play tones as announcements by using stored files. This mode does not use DSP resources. NOTE: |
|
...
...
If this flag is disabled, the SBC uses DSP (TNAPAD) to generate and play tones. | | With or Without SDP | Use this flag to specify whether to play tones when a P-Early-Media (PEM) header is received in the 18x response, with or without SDP. To configure this flag, the Early Media Method flag must be configured as P Early Media. | | Early Media Method | This flag is used to specify whether playing tones is governed by receipt of a PEM header. The options are: - P Early Media - the SBC plays tones when it receives a PEM header.
- None (default) - the SBC is not governed by the PEM header.
|
|
Specifies Dynamic Lrbt state:
...
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.