Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to All

Back to All - Address Context

Back to Address Context - Zone

Back to Zone - Ip Peer

Use this object to support local authentication autonomously on a per-IP trunk group basis in situations where an IP-PBX does not perform a registration and the service provider does not require/want registrations. Refer to IP Trunk Group Authentication for additional feature functionality.

To View and Edit Authentication

On SBC main the

Spacevars
0product
 main screen, go to All > Address Context > Zone > Ip IP Peer > Authentication. The Authentication window is displayed.

The Authentication can be checked for each Address Context, for each Zone, for each Ip IP Peer created or for all the Address Contexts, Zones and Ip IP Peers created. Use the drop-down box to select the desired Address Context, Zone and Ip IP Peer.

Caption
0Figure
1System Provisioning - Ip IP Peer - Policy - Sip Main Field
Image Added 

Image Removed 

The Edit Authentication window is displayed.

Caption
0Figure
1Zone - Ip IP Peer - Authentication
Image Added 

Image Removed 

The following fields are displayed:

Caption
0Table
1Zone - Ip IP Peer - Authentication
 
ParameterDescription
Int Challenge Response

Enable this flag on the ingress IP Peer to allow the SBC to reply to local authentication challenges autonomously. If this flag is disabled, the SBC will not reply to authentication challenges locally even if credentials are configured on the egress IPTG. The options are:

  • disabled (default)
  • enabled
Inc Internal Credentials

Enable this flag on the ingress IP Peer to allow egress IPTG authentication to be internally created using the authorization information in mid-dialogue without being challenged. The options are:

  • disabled (default)
  • enabled
Note

If Int Challenge Response is disabled, Inc Internal Credentials is not used.

Note

If IP Trunk Group (IPTG) authentication is configured for both ingress IPTG sipTrunkGroup and ingress IP Peer, the IP Peer configuration takes will take precedence.

If you wish to use the intChallengeResponse and incInternalCredentials flags configured solely on IPTG, the IP Peer must not be present in the configurations. Otherwise, the IP Peer flags default to 'disabled' state and take precedence over IPTG flags.the sipTrunkGroup level, IP addresses of the IP Peers which SBC receives SIP messages from must not match any IP address of the configured IP peers in the ingress signaling zone. If the source IP address of received SIP messages match an IP address of any IP Peer in the signaling zone, the intChallengeResponse and incInternalCredentials flags on the ipPeer level will take precedence.

 


Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

Pagebreak