Page History

Overview

Procedure

Perform the following procedure to accomplish the following:

1. Create a Relay Profile

2. Assign the Relay Profile to Ingress and Egress TCP Relay Ports

3. Create IP Peer Routing Label

4. Create a Relay Route to Specify How to Route Incoming Call

Anchor
Create a Relay Profile Create a Relay Profile

1. Create a Relay Profile

Create a Relay Profile specifying ingress and egress CAC parameters as well as TCP keep-alive value.

set profiles services relayProfile RP1 maxEgressConn 10 maxEgressRate 50 maxIngressConn 100 maxIngressRate 80 tcp keepAlive 100

Anchor
Assign the Relay Profile to ingress and egress TCP relay ports Assign the Relay Profile to ingress and egress TCP relay ports

2. Assign the Relay Profile to ingress and egress TCP relay ports

Create an ingress egress TCP relay port and assign the relay profile (Use the IP Address of the SIP Signaling port).

set addressContext AC1 zone AC1Z1 id 2 relayPort 3 ipAddress 10.7.14.41 portNumber 2024 ipInterfaceGroupName IG1 transportProtocolsAllowed tcp relayProfile RP1 state enabled mode inService

Anchor
Create IP Peer Routing Label Create IP Peer Routing Label

3. Create IP Peer routing

Label

Create Routing Label for IP Peer.

set global callRouting routingLabel RL_EGRESS routingLabelRoute 1 routeType ipPeer ipPeer ipPeer1

Anchor
Create a Relay Route to Specify How to Route Incoming Call Create a Relay Route to Specify How to Route Incoming Call

4. Create a Relay Route to

Specify How to Route Incoming Call

Create a Relay Route to specify how the call coming in on a particular relay port must be routed.