Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH2sbsarkar
AUTH1pmuthu
REV5bscoggins
REV6bscoggins
REV3rasahoo
REV1tasveren

Panel

In this Section:

Table of Contents

 

 

Info
titleNote

This object is visible and configurable only for SBC SWe Cloud. Refer to Configuring an SBC SWe Cluster using the EMS for information on configuring SWe Cloud deployments.

The SBC SWe Cloud supports configuring a Load Balancing Service (LBS) to distribute cluster information between D-SBC instances. 

To configure an LBS on a PKT port (any IP Interface other than MGMT), set "clusterAdmin clusterComm type ip" before the LBS configuration on an M-SBC. Refer to Support Intra-Cluster VNFC Communication Through Packet Ports by Assigning an IP Interface Group in CLI.

Configuring Load Balance Service

  • Log on to the EMA Configurator as admin.
  • Click All tab.

    • On the navigation pane:

    1. ,

      click All > System > Load Balancing Service

      .

      You can modify the Group Name and Private IP Interface Group Name. Click Save.

       
      Caption
      0Figure
      1Load Balancing Service - M- MSBC
      SBC

      Image Modified

      Caption
      0Figure
      1Load Balancing Service - SSBCS-SBC

       

      Image Removed

      Image Added

    2. Use the table to edit the configurations and click Save.

    Parameter

    Description

    Descriptions

    Caption
    0Table
    1Parameter DescriptionDescriptions
    ParameterDescription
    groupNameGroup Name<name> – Domain name of the load balancing group..
    Private IP Interface Group NameThe name of the Private IP Interface Group used by an M-SBC or T-SBC to communicate with the MRF.

    Invite Retarget ModeinviteRetargetMode

    Specifies the load balancing service mode for INVITEs. Enables load balancing for initial INVITE requests. 

    If set to redirect, calls may get retargeted using SIP 302 to balance the load.

    • disabled Disabled (default)
    • redirectRedirect

    registerRetargetModeRegister Retarget Mode

    Specifies the load balancing service mode for REGISTERs. Enables load balancing for REGISTER requests.

    If set to redirect, new registrations may get retargeted using a SIP 302 message to balance the load.

    <name> – The name of the Private IP Interface Group used by M-SBC/T-SBC to communicate with MRF.
    • disabled Disabled (default)
    • redirect
    		privateIpInterfaceGroupName
    • Redirect

    Pagebreak