Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migration of unmigrated content due to installation of a new plugin

Workflow approval customer doc
approversradichkd
smesgezerh
 
This section describes the steps for inserting and removing Interface Cards from the rear of the Sonus SBC 1000/2000 chassis.
Wiki Markup
{multi-excerpt-include:pageTitle=_BoilerPlate|name=hw-service-warning|nopanel=true}
Table of Contents
maxLevel3

...

 

Multiexcerpt
MultiExcerptNameremove
Wiki Markup
h4. To Remove an Interface Card
# Power down the SonusRibbon SBC 1000/2000.
{multi-excerpt-include:pageTitle=_BoilerPlate|name=warn-icard-hotswap|nopanel=true}
# Loosen the screws on the right and left side of the interface card until they spin freely.
# Depress the red buttons on the inside of the attachment levers until they click and lock into place. The Hot Swap status LED should now be lit.
# Grip the inside of the attachment levers and push toward the outside edges of the card.
# Carefully pull the card free of the chassis.

...

Wiki Markup
{multi-excerpt-include:pageTitle=_BoilerPlate|name=warn-icard-hotswap|nopanel=true}
Multiexcerpt
MultiExcerptNameinsert

To Insert an Interface Card

  1. Carefully insert the card so that the left and right edges slide into the mounting slots.
  2. Grip the outside of the attachment levers and push toward the inside of the card until the card locks into place.
    (info) The red buttons click and pop out when the card is properly locked into place.
  3. Tighten the screws on the right and left side of the interface card.
Panel
bgColor#FFFFFF
borderStylenone
Caption
0Figure
1Insert the Card

Panel
bgColor#FFFFFF
borderStylenone
Caption
0Figure
1Lock Card in Place

Pagebreak