Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH2UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cd5909df, userName='null'}
AUTH1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c85b00e8, userName='null'}
REV5UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cca00892, userName='null'}
REV6UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c749000c, userName='null'}
REV3UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c85b00e8, userName='null'}
REV1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c85b00e8, userName='null'}

Panel

In this section:

Table of Contents
maxLevel3

 

Overview

As part of

Spacevars
0product
switch-over process, the
Spacevars
0product
must move the IP (floating IP) to a different NIC. The
Spacevars
0product
reconfigures the NICs appropriately and then broadcasts a GARP reply to inform neighboring devices about the change in the MAC address for the floating IP. Devices that receive the ARP packet then update their ARP tables with the new MAC address.

Note

There is a minor

...

difference between 

Spacevars
0company
'
Spacevars
0product2
and hardware-based
Spacevars
0product
s. For the case of hardware-based SBCs during a switchover, both the IP and MAC addresses of the active node's non-management interfaces are migrated to the standby. For SBC SWe during a switchover, only the IP address is migrated from active to standby (the newly active node will use its own MAC addresses).

In both cases, the L2 tables of attached switches are updated; however in the case of SBC SWe, the routers' ARP tables must be updated as well.

Info
ARP cache entries on the router are cleared periodically, typically every 10-20 minutes.  As a result, the ARP table on the router gets updated. At this point, the active CE starts receiving traffic.

Configuring Routers in SBC SWe Network

If a router in an 

Spacevars
0product2
network is not configured properly to handle Gratuitous Address Resolution Protocol (GARP) replies, calls will fail after an 
Spacevars
0product2
switch-over.

Note

For example, the received Gratuitous ARP reply on a Juniper SRX device does not update the ARP cache by default. You must configure the router to enable ARP table update for switch-over to work properly.

A knowledge base article on how to enable the updating of the ARP cache for received gratuitous ARP replies is located here:

Link_in_new_tab
Texthttp://kb.juniper.net/InfoCenter/index?page=content&id=KB24349
URLhttp://kb.juniper.net/InfoCenter/index?page=content&id=KB24349

Pagebreak