Add_workflow_for_techpubs | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Panel | |
---|---|
In this section:
|
Upgrading from an SBC 3.1.x/4.x involves:
Upgrading Firmware the firmware (not applicable to SBC SWe).
Info | ||||
---|---|---|---|---|
| ||||
This step upgrades the BMC for the 5xx0 series, 5400 and 7000 series, and the BIOS and additional firmware for the SBC 5400 and 7000 series. |
Upgrading the SBC Applicationapplication.
Info | ||||
---|---|---|---|---|
| ||||
This step upgrades the OS for the 5xx0, 5400, and 7000 series and the BIOS for the 5xx0 series. |
The Standalone standalone and HA upgrade flows below are are shown for general guidance. Actual software and firmware versions may vary depending upon the upgrade path:
Hide If | ||||||
---|---|---|---|---|---|---|
| ||||||
|
Show If | ||||||
---|---|---|---|---|---|---|
| ||||||
|
Note |
---|
The Platform Manager (PM) is available and must be used only from SBC release 3.0.0 or later. The LSWU upgrade is not supported directly from 3.0.0 to 5.0.0 release. |
0 | Figure |
---|---|
1 | Standalone Upgrade Flow Diagram |
Caption | ||||
---|---|---|---|---|
| ||||
|
Caption | ||||
---|---|---|---|---|
| ||||
Application | Specified Version |
---|---|
SBC core | 8.1.0 |
BMC | 3.2 |
Pagebreak |
---|
Hide If | ||||||
---|---|---|---|---|---|---|
| ||||||
|
Show If | ||||||
---|---|---|---|---|---|---|
| ||||||
| ||||||
Note | ||||||
The Platform Mode (PM) is available, and must be used from SBC release version 3.0.0 or later
|
Caption | ||||
---|---|---|---|---|
| ||||
Pagebreak |
---|