Add_workflow_for_techpubs | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Info | ||
---|---|---|
| ||
Applicable only for CALEA users |
This section briefly describes the commands for configuring LI on M-SBC.
Info | ||
---|---|---|
| ||
|
Code Block |
---|
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <Default LI supported Value> vendorId <Default LI Supported Values> |
Info | ||
---|---|---|
| ||
For Default/Legacy LI on the M-SBC, ensure that the LIF group name used to send the X3 intercepted data is the same as the interface name in the S-SBC (used to send the X2 data on the S-SBC). |
To configure IMS LI on M-SBC, configure the Media (X3) interface using the two commands shown below:
Tip | ||
---|---|---|
| ||
Perform a commit after each step. |
Code Block |
---|
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <IMS LI flavor> vendorId <IMS LI Falvour>flavor> mediaIpInterfaceGroupName <LIG1 from which wherethe data is sent> % set addressContext default intercept callDataChannel <CDC Name> mediationServer <mediation server name> media <transport type> ipAddress <ip address of mediation server> portNumber <port number of mediation server> |
Tip | ||
---|---|---|
| ||
Perform a commit after each step. |
Code Block |
---|
% set addressContext default intercept callDataChannel <CDC Name> interceptStandard <PSCI LI supported value> vendorId <PSCI LI supported value> mediaIpInterfaceGroupName <LIG1 from where data is sent> % set addressContext default intercept callDataChannel <CDC Name> mediationServer <mediation server name> media <transport type> ipAddress <ip address of mediation server> portNumber <port number of mediation server> # To activate: set addressContext default intercept callDataChannel <CDC Name> mediationServer <mediation server name> media <transport type> state enabled mode inService |