Add_workflow_for_techpubs |
---|
AUTH1 | UserResourceIdentifier{userKey=8a00a0c85bb25531015bc4122a4f0003, userName='null'} |
---|
REV5 | UserResourceIdentifier{userKey=8a00a0c85bb25531015bc4122a4f0003, userName='null'} |
---|
REV6 | UserResourceIdentifier{userKey=8a00a0c85bb25531015bc4122a4f0003, userName='null'} |
---|
REV3 | UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cef30cd0, userName='null'} |
---|
REV4 | UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cef20cbf, userName='null'} |
---|
REV1 | UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ca2f03d1, userName='null'} |
---|
|
Note |
---|
This procedure is not applicable to the ; Ribbon Application Management Platform is configured during the initial deployment of the via Azure Marketplace. |
Excerpt |
---|
The Ribbon Application Management Platform can launch an instance's UI in your internet browser, which allows you to configure, operate, and monitor the instance if the remote UI connection is currently active. For example, you can configure the RAMP Connector logging and view the current connection and remote UI status of the Ribbon Application Management Platform connection. Info |
---|
| This feature for the requires the Ribbon Application Management Platform 21.11 Release or later. |
With the Ribbon Application Management Platform enabled, the sends a SIP signaling group (SG) and port status report and the most recent, highest severity alarm to the Ribbon Application Management Platform. The SIP SG and port status report includes information about the SIP SG and port's unique ID, administrative status, and real-time status. Info |
---|
| If a timeout results in the runtime status not being retrieved, then the reports the real-time status as Unknown. |
To enable the Ribbon Application Management Platform, you must configure the Ribbon Application Management Platform panel (see the following procedure) according to your :- - Configure the IP address or FQDN.
- - Configure the IP address or FQDN and the Management ID.
Note |
---|
| When you enter the Management ID, you must insert a colon every two characters (00:00:00). Otherwise, the cannot connect. |
|
...