Page History
This article describes the steps necessary to configure the
Spacevars | ||
---|---|---|
|
Spacevars | ||
---|---|---|
|
Section | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Spacevars | ||
---|---|---|
|
...
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Transformation
- Add a new Transformation Table.
Add two entries to the new Transformation Table configured as follows:
Caption 0 Table 1 Transformation Table Configuration
Input Field Type Input field Value Output Field Type Output Field Value Match Type Description Called Address Number .*6(\d{3})$ Called Address/Number 6/1 Mandatory LyncSetup: Full Number Calling Address Number (.*) Calling Address/Number \1 Mandatory LyncSetup: Full Number
Call Routing Table Configuration
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Call Routing Table.
- Add a new Call Routing Table.
Add an entry to the new Call Routing Table and configure with the values below; keep the fields not listed as the default values.
caption0 Table 1 Call Routing Table Configuration
Field Value Number/Name Translation Table Select appropriate Translation Table (i.e., Calls to ISDN phones) Destination Signaling Group Select appropriate Signaling Group (i.e., ISDN:Lync Setup)
SIP Signaling Group Configuration
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Signaling Groups.
Add a new SIP Signaling Group and configure it with the values below; keep the fields not listed as the default values.
caption0 Table 1 Call Routing Table Configuration
Field Value SIP Mode Local Registrar Registrar SIP Phones
ISDN Port Configuration
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Node Interfaces > Ports.
- Click the port you wish to configure.
Configure the port with the values listed below; keep the keep the fields not listed as the default values.
Caption 0 Table1
Call Routing Table ConfigurationField Value Port Alias Specifies an alias for the port (i.e., T1 to Meridian) Description Specifies the description (i.e., T1 to Meridian)
ISDN Signaling Group Configuration
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Signaling Groups.
- Add a new ISDN Signaling Group.
Configure the new ISDN Signaling Group with the values listed below; keep the fields not listed as the default values.
Caption 0 Table1
Call Routing Table ConfigurationField Value Description Description of Signaling Group Switch Variant QSIG Tone Table Default Tone Table Call Routing Table Select appropriate Call Routing Table
Verification
Endpoint Registration:
...
Using the Log Exchange utility, you can quickly verify the relevant SIP messaging:
...
borderStyle | none |
---|
...
Verify SIP Messaging