Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note
titleRibbon 1000/2000 Systems with Built-in ASM

If your ASM is already initialized and Lync SBA is deployed, resetting the SBC to factory defaults does not reset the ASM/SBA configuration settings. If you wish to reset the ASM to factory defaults, then you must Re-initialize the ASM.

...

  1. If the SBC is running, press and hold the Reset button for approximately 20 seconds.

  2. Shut down the SBC, press and hold the reset button while the unit is powered on. Hold the reset button until the Alarm Status LED first turns yellow and then goes out.

    ExpandClick here to see where the Sonus SBC 1000 Reset button is locatedClick here to see where the Sonus SBC 1000 Reset button is located Caption0Figure1



    SBC 1000 Reset Button:
    Image Modified

    ExpandClick here to see where the Sonus SBC 2000 Reset button is located


    Click here to see where the Sonus

    SBC 2000 Reset

    button is located Caption0Figure1SBC 2000 Reset Button

    Button:
    Image Modified

After the SBC system has booted, it can be re-initialized by Running Initial Setup.

...

  1. In the WebUI, click the Tasks tab.

  2. In the left navigation pane, go to System > 

    Spacevars
    0product
    Factory Default.

    Panel
    borderStylenone
    Caption0Figure1Factory Default for SBC 1000/2000 and SBC SWe Edge


     Image Modified

    Panel

    borderStylenone
    Caption
    0Figure
    1Factory Default for Cloud Native SBC SWe Edge

    Image Removed
     


Operation Selections

Factory Default

Panel
bgColor#FAFAFA
borderStylenone

This selection performs a total factory reset. After the operation is complete, the SBC can be re-initialized by Running Initial Setup.

Partial Reset

...

Panel
bgColor#FAFAFA
borderStylenone

This selection removes all configuration information from the SBC with the exception of the Logical Interfaces, Ethernet ports, VLANs, ACLs, Static Routes, ASM Networking, Node-Level Settings and Certificate configurations. With this option the SBC can still be reached through a browser pointed at its application IP Address.

...