Overview
Multiexcerpt include |
---|
MultiExcerptName | ICMP_ping |
---|
PageWithExcerpt | Path Check Support |
---|
|
Perform the following steps to configure path check path using ICMP ping:
Anchor |
---|
| Configuring the Static Route |
---|
| Configuring the Static Route |
---|
|
Configuring the Static Route
To configure the static routes to reach the target IP from interface, execute the following command:
Code Block |
---|
% set addressContext default staticRoute 10.54.80.155 32 10.54.114.1 LIF1 lif_eth2 preference 100
% commit |
Anchor |
---|
| Configuring the Path Check Path Profile |
---|
| Configuring the Path Check Path Profile |
---|
|
Configuring the Path Check Path Profile
To configure the pathCheckProfile
, execute the following command:
Code Block |
---|
% set profiles services pathCheckProfile TP1 protocol icmp replyTimeout 5 sendInterval 10 failureResponseCodes all4xx recoveryCount 1 replyTimeoutCount 10 transportPreference preference1 tcp preference2 udp
% commit |
Anchor |
---|
| Configuring Path Check Path Object |
---|
| Configuring Path Check Path Object |
---|
|
Configuring Path Check Path Object
Code Block |
---|
% set system pathCheckPath PATH1 sourceIpAddress 10.54.114.156 targetIpAddress 10.54.80.155 reportSignalIpAddress 10.54.80.156 reportSignalIpPort 3456 pathCheckProfile TP1 zone INTERNAL ipInterface lif_eth2 addressContext default ipInterfaceGroup LIF1 state enabled
% commit
|
Anchor |
---|
| Creating User ACL for ICMP (Optional) |
---|
| Creating User ACL for ICMP (Optional) |
---|
|
Creating User ACL for ICMP (Optional)
The user ACL for ICMP must be created if there are more than 50 sessions. To create the user ACL, execute the following command:
Include Page |
---|
| _IP_Access_Control_List_a_Condition_for_Using_Fill_Rate_and_Bucket_Size |
---|
| _IP_Access_Control_List_a_Condition_for_Using_Fill_Rate_and_Bucket_Size |
---|
|
For IPv4:
Code Block |
---|
% set addressContext default ipAccessControlList rule Rule1 action accept protocol icmp fillRate 300 bucketSize 50 precedence 1 state enabled
% commit |
For IPv6:
Code Block |
---|
% set addressContext default ipAccessControlList rule Rule1 action accept protocol icmpv6 fillRate 300 bucketSize 50 precedence 1 state enabled
% commit |
Anchor |
---|
| Viewing the ICMP Protocol |
---|
| Viewing the ICMP Protocol |
---|
|
Viewing the ICMP Protocol
To view the ICMP protocol, enter the following command:
Code Block |
---|
> show table addressContext default ipAccessControlList rule test
precedence 1;
protocol icmp;
action accept;
fillRate 300;
bucketSize 50;
state enabled;
aggregatePolicer OPERATOR;
[ok] |
pagebreak