Page History

To Use the following procedures to configure SD-WAN on EdgeMarc.

Configure EdgeMarc to support SD-WAN

To configure

1. Choose Devices > List.

   Caption
   0 Figure 1 EdgeView Devices Menu 3 EdgeView Devices Menu
   Image Modified

   The 

   Spacevars
   0 product3

    devices list appears.

   Caption
   0 Figure 1 EdgeView Devices

   list

   List 3 Devices List_1

   Image Modified

   
   

2. Select the required device to configure (see EdgeView Devices list image). The 

   Spacevars
   0 product3

    device details page appears.

   Caption
   0 Figure 1 EdgeMarc Device

   details

   Details 3 Devices Page - Configure SD-WAN

   Image Modified

   The 

   Spacevars
   0 product3

   Device page contains WAN Health details in the form of Link Quality graphs, WAN Traffic graphs, and Total Peak Calls graph, in addition to basic details about the 

   Spacevars
   0 product3

   device.

   Info
   title Note
   The SD-WAN Link Quality graphs will not be displayed if SD-WAN is not licensed on your device.

   
   

3. To configure SD-WAN, select CONFIGURE SD-WAN from the 

   Spacevars
   0 product3

    devices page (see EdgeMarc Device details image).
   The SD-WAN Business policy page appears.

   Caption
   0 Figure 1 Business Policy 3 Business p1
   Image Modified

   
   

   Tip
   title Tip
   You can now configure SD-WAN by adding a Business Policy Rule.

...

Add Business Policy Rule

Business policy rules allow the system to classify traffic flow into classes of service based on their URL, IP Address, or destination port. When a rule is configured and saved, the system will modify each packet in the flow with the configured data priority. The packet then enters the traffic shaper and based on data priority, the shaper applies the prioritization and bandwidth guarantees for the class-of-service the packet belongs to.

To add a business policy rule, perform the following steps from the Business Policy page:

1. Select the traffic method of the policy.

   Caption
   0 Figure 1 Bulk Actions 3 Bulk Actions
   Image Modified

   
   

2. Enter a Rule Name for business policy.
3. Enter the Url/IP of the business policy.

4. Select the Link Steering of the policy (see Link Steering image)
   Link Steering displays the interface preference for the configured rule. When the rules’ Link Steering is configured to Auto, the system will analyze traffic and apply the Routing Decision Preference and settings on the Advanced page.This will determine which WAN the rules traffic should be routed through.

   Caption
   0 Figure 1 Link Steering 3 Link Steering
   Image Modified

   
   

5. Select the Priority and then click ADD.

   Caption
   0 Figure 1 Priority 3 Priority
   Image Modified

   The business policy is added successfully.

   Caption
   0 Figure 1 Business Policy 3 Business Policy 2
   Image Modified

   Pagebreak