Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: image borders
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents 

Back to Media Services

The Media Antitrombone feature employs the “C” line trigger to use a signaling loop to pass media directly between two endpoints. This technique supports bandwidth optimization since the

...

Spacevars
0series4
 is not required to handle media once the signaling loop is identified. This feature also supports SIP signaling in all the transports: UDP, TCP, TLS, IPSec, IPv4, and IPv6.

Caption
0Figure
1RTP Pass-through or Transcoding Using Media Loop

...

3RTP Pass-through or Transcoding Using Media Loop

Image Modified

Note
The Media Antitrombone feature mainly applies to IP PBX scenarios, and is useful in situations where X-DMI cannot be passed through the SIP server.

Media Antitrombone is similar to Direct Media method, but eliminates the dependency on X-DMI header to identify the direct media. Media Antitrombone instead uses SDP “C” line for the identification of the signaling loop. The following diagrams show a typical RTP pass-through (or transcoding) using media loop application, and then the same call flow using Media Antitrombone feature.

Caption
0Figure
1

...

Image Removed

 

 

 

...

Media Antitrombone Methodology
3Media Antitrombone Methodology

Image Added

Pagebreak