Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: corrected per comment on ICD page from Shripal

Add_workflow_for_techpubs
AUTH1
REV5
REV6
REV3
REV1

 

Panel

In this section:

Table of Contents

 

The SIP out-of-dialog (OOD) licensed max rate limit specifies a global rate limit for incoming OOD messages, per second. In calculating the rate, the SBC counts all SIP out-of-dialog requests except INVITE and REGISTER requests. The purpose for the configured limit is to specify when to alert an operator that the limit is exceeded. When the configured message rate is exceeded, the SBC generates a trap. A clear trap is generated when the message rate falls to 90 percent or less of the configured rate limit.

Command Syntax

To The CLI syntax to configure the licensed out-of-dialog rate limit is shown below:

 

Code Block
% set global sipOod licensedMaxRateLimit <unlimited | 1-655355>65535>

 

Command Parameters

Caption
0Figure
1SIP OOD Rate Limit Parameter
Parameter
Length/Range
Default
Description
licensedMaxRateLimit

1-65565535 seconds, 355or unlimited

unlimited 

Sets Use this parameter to set the OOD licensed rate limit value. When exceeded the SBC generates a trapan alarm.

Configuration Example

 

Code Block
% set global sipOod licensedMaxRateLimit 2197
% commit
% [ok] [2018-09-27  23:23:56]