Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Minor page formatting.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to CLI Configure Mode

Back to System - CLI

...

Panel

In this section:

Table of Contents
maxLevel2

Available_since
TypeModified For
Release5.0.1

 

The Logical Management IP Interface is a virtual management IP interface configurable using CLI syntax described in this section.

Info
titleNote

A Logical Management Interface must include both physical management interfaces. Therefore, it should contain all four interfaces. Otherwise, this will result in a confd restart and ahealthcheck timeout (system down time) if the physical interface underlying the logical interface goes down.

 

Command Syntax

Code Block
languagenone
set system logicalMgmtIpInterface <intfc_name>
	ipAddress <ip address>
	mgmtIpInterfaceGroupName <name>
	state <disabled | enabled>
	useIpAddrAsSnmpSource <false | true>

Command Parameters

Caption
0Table
1Logical Management IP Interface

Parameter

Description

logicalMgmtIpInterface

The logical management IP interface name.

ipAddress

The logical IP address of the interface. The following IP address types are supported:

  • IPv4 – Uses dotted decimal format (for example 128.127.50.224).
  • IPv6 – Uses hexadecimal/colon format (for example, 1280:1276:3350:2224:2222:3333:8888:1245 or fd00:21:445:128::7880).

mgmtIpInterfaceGroupName

The name of the management IP interface group used by this logical IP interface.

state

Administrative state of the logical management IP interface.

  • disabled (default) – The logical management IP address is not being used for chassis management.
  • enabled – The logical management IP address is being used for chassis management.

useIpAddrAsSnmpSource

Set this flag to “true” to receive SNMP requests on this logical management IP address

...

, and to use this address as the source for SNMP responses, alarms and traps.

  • true
  • false (default)

NOTE: This flag can only be enabled on one logical management interface at a time.

 

Command Example

To display the logical management IP interface configuration:

Code Block
languagenone
% show system logicalMgmtIpInterface LogMgmt  
	mgmtIpInterfaceGroupName mgmtGroup;  
	ipAddress 3FFE:1900:4545:3:200:F8FF:FE21:67CF;  
	state enabled;
	useIpAddrAsSnmpSource true;

To display the logical management IP interface configuration for two subnets:

Code Block
languagenone
 % show system logicalMgmtIpInterface 
	logicalMgmtIpInterface AGMGM { 
		mgmtIpInterfaceGroupName mgmtGroup1; 
		ipAddress 10.54.67.50; 
		state enabled;
		useIpAddrAsSnmpSource disabled;
	} 
	logicalMgmtIpInterface HAMGM { 
		mgmtIpInterfaceGroupName mgmtGroup; 
		ipAddress 10.54.66.65; 
		state enabled; 
		useIpAddrAsSnmpSource disabled;
	}

 

...

Info
titleNote

When configuring the management interfaces on two subnets, a logical management IP interface is needed for each subnet.

Pagebreak