Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel

...

 

...

...

Back to Table of Contents

Back to SBC Network Deployment Scenarios

Back to H.323 Deployment Scenarios

In this section:

Table of Contents
maxLevel2
minLevel1

Scenario

Configuring H.323 peering across Carrier-A and Carrier- B, and routing calls between the carriers.

Background Information

  • The system is installed in a service-provider's network interconnecting two of its customers.
  • The system exposes only the Trunk Group based routing and the Trunk Group/H.323 Server combination based routing models.
  • The customers' networks are represented by specific points of contact, i.e. by H.323 Servers, rather than a set of machines (h323TrunkGroup).
  • The requirements specified in the section "Background Information and Dependencies" under Minimal Out-Of-The-Box Configuration are met.
  • Ports and IP Interface Groups have been configured as described in NNI: Complex route selection.

Configuration Steps

  1. Set "CLI context" to default Address Context.
    Default is pre-created, but must set command-line context to it in order to create sub-objects within it.
  2. Create a Zone with name "Carrier-A". This Zone can use LIFGroup1 by default as this is the only IP InterfaceGroup defined in this Address Context.
  3. Create a H.323 with name "GCTrunkGroupA" within Zone "Carrier-A". Associate the TrunkGroup with the IP address ranges from Carrier-A.
  4. Create a H.323Server with name "GCPeer" within Zone "Carrier-A".
    1. Set the IP Address of the H.323Server as 1.1.1.2.
  5. Create a Zone with name "Carrier-B". This Zone can use LIFGroup1 by default as this is the only IP InterfaceGroup defined in this Address Context.
  6. Create a H.323 with name "GCTrunkGroupB" within Zone "Carrier-B". Associate the TrunkGroup with the IP address ranges from Carrier-B.
  7. Create a H.323Server with name "Carrier-B Peer" within Zone "Carrier-B". Set the IP Address of the H.323Server: 3.3.3.2.
  8. Create Routes to route calls from Trunk Group “GCTrunkGroupA” to egress Trunk Group  “GCTrunkGroupB” and Peer “CarrierBPeer”.
  9. Create Routes to route calls from Trunk Group “GCTrunkGroupB” to egress Trunk Group  “GCTrunkGroupA” and Peer “CarrierBPeer”.
    The system will now route the traffic from Carrier-A to Carrier-B and vice-versa.

...

Pagebreak