Panel | |
---|---|
In this section:
|
This article explains the configuration steps necessary to allow SIP calls in an IP.PBX(1) –
...
Ribbon SBC 1000/2000 – IP.PBX(2) topology as illustrated in the diagram below. For the purpose of this article, it is assumed that the IP.PBX - Border Elements - are configured to send/receive SIP calls:
Table of Contents | ||||
---|---|---|---|---|
|
Topology |
---|
...
Spacevars | ||
---|---|---|
|
...
The following configuration steps must be accomplished in the order presented as shown below.
Add a Tone Profile Table (named SIPtrunking: Tone Table)
...
...
...
...
...
...
...
...
...
...
...
...
Configure the new entries from the previous step
...
.
...
...
...
Configure the entries created in the previous step
...
.
...
SIP Signaling Group #1 |
---|
...
SIP Signaling Group #2
...
...
...
...
...
Once the above configuration steps have been completed, a SIP call from Border Element 1 (IP-PBX-1) to Border Element 2 (IP-PBX-2) using
...
Spacevars | ||
---|---|---|
|
Spacevars | ||
---|---|---|
|
Panel | |||||||
---|---|---|---|---|---|---|---|
| |||||||
|