Noprint | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
The BMC web application allows provisioning primary and secondary of the four host management interfaces. When the host management interfaces are configured, a direct link from BMC is enabled to the EMA/EMA Platform Mode for installing and upgrading the
Spacevars | ||
---|---|---|
|
Info | ||
---|---|---|
| ||
Related article:
|
Use the following procedure to configure the primary and secondary 4 host management interfaces:
Log on to SBC BMC GUI using the IP address configured in one of the previous sectionsections.
Info | ||||
---|---|---|---|---|
| ||||
Use any one of the following methods to obtain the BMC IP address: - Configuring SBC 5400 BMC IP Address Via Serial Console Or | ||||
Code Block | ||||
| ||||
username: root password: superuser |
The BMC Main Screen appears:
Caption | ||||
---|---|---|---|---|
| ||||
Click Navigate to Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.
Info | ||||
---|---|---|---|---|
| ||||
Refer to SBC 5400 Media Ports and Operational Modes to know more about these four media ports and their operational modes. |
The SBC 5400 platform includes the following configurable media port configurations.
Caption | ||||
---|---|---|---|---|
| ||||
Info | ||||
---|---|---|---|---|
| ||||
A message appears to enter the management IP addresses for the first time installation. |
If the management interfaces have not yet been configured, a warning message appears. Click OK to proceed with the Management Port configuration.
Caption | ||||
---|---|---|---|---|
| ||||
- IPv4 Address or/and IPv6 Address
- Prefix
- Default Gateway, Prefix and Default Gateway
- IPv6 Address, Prefix and Default Gateway
Info | ||||
---|---|---|---|---|
| ||||
The IPv4 Address, Prefix and Default Gateway should be configured for Management Interface "0". For all other Management Interfaces, the settings are optional. |
Caption | ||||
---|---|---|---|---|
| ||||
Click Save.
...
Info | ||||
---|---|---|---|---|
| ||||
Once you save the changes to the Management IP addresses, a warning message appears. Note that the changes to the Management IP addresses will only take effect when the SBC application is Installed (or re-Installed if already present). Refer to SBC 5400 - Installing Application for more information. |
Caption | ||||
---|---|---|---|---|
|
...
...
Pagebreak |
---|