Page History

Once you have updated the inactive partition either by by Upgrading the Inactive Partition or by – SBC Edge or by Uploading Firmware Patches, new software does not take effect until you activate newly updated partition. When you activate the partition, the system must reboot to boot from the desired partition. All configuration is preserved when you activate the partition.

To set the Active Partition:

1. In the WebUI, click the the Settings tab tab.

2. In the left navigation pane, go to to System > Software Management > Application Partitions.

   Image Removed

   Panel
   borderStyle none
   Caption 0 Figure 1 Application Partitions Image Added

3. Click the Set Active link Click the Set Active link in the row entry associated with the partition that you wish to activate.
   The inactive partition is the row entry listed without a tick mark under the 'Active Partition' column

4. You will be prompted to reboot the Sonus the Sonus SBC 1000Edge/2000SBC SWe Lite, click click OK.

   Panel
   borderStyle none
   Caption 0 Figure 1 Reboot Prompt Image Modified

   Note
   It will take up to 15 seconds for the action to be processed, and you will not see any visible indication during this short period of time.

5. The following status message will be dispatched indicating that the system is rebooting off of the new partition

   Image Removed

   Panel
   borderStyle none
   Caption 0 Figure 1 Status Message Image Added