Page History
...
- In the mounting hardware bag provided with the Sonus SBC 2000 system, find the rear support brackets (2) and 9-inch extension arms (2).
- If you are installing the Sonus SBC 2000 system into a 30-inch depth rack, attach the extension arms to the support brackets.
Attach the support brackets securely to the two rear posts of your equipment rack. Refer to the illustration below for visual details of the assembly:
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Assemble and Install Rear Support Brackets 
| Note |
|---|
The illustration above shows the rear bracket assembly for a rack with a 30-inch depth. For racks with a 24-inch depth, do not use the 9-inch extension arm and attach each support bracket directly to the rear rack posts. |
...
- Attach the 2 rack mounting ears securely to the front corners of the Sonus SBC 2000 chassis.
- Attach the 2 pan handle plates securely to the rear corners of the Sonus SBC 2000 chassis.
- Working with a partner, lift the Sonus SBC 2000 chassis and slide it into the equipment rack, making sure to seat each pan handle plate into the support brackets mounted on the rear support posts.
Attach the 2 rack mounting ears securely to the front mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install in 4-Post Equipment Rack 
| Warning |
|---|
Do not block the air vents on either side of the Sonus SBC 2000 chassis. Both sides of the unit must clear to ensure proper cooling of the unit. |
| Pagebreak |
|---|
Installing the Sonus SBC 2000 Chassis in a 2-Post Equipment Rack
...
- Attach the 2 rack mounting ears securely to the center mounting points on both sides of the Sonus SBC 2000 chassis.
Attach the 2 rack mounting ears securely to the mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install in 2-Post Equipment Rack
Installing Interface Cards
...
| Warning |
|---|
You must power down the Sonus SBC 2000 system before installing or removing Interface Cards. Hot swapping of Interface Cards is not supported in Sonus SBC 2000 4.0.x. |
...
| Wiki Markup |
|---|
{multi-excerpt-include:pageTitle=Inserting and Removing Interface Cards|name=insert|nopanel=true} |
| Pagebreak |
|---|
Installing Ground Wire, Power Cables and Connect Power
...
Place the cable management bracket on top of the pan handle plates.
Note If you have installed the Sonus SBC 2000 chassis in a 2-post configuration, you must install the pan handle plates on the rear corners of the chassis.
Use the provided cable ties to secure the cable management bracket to the pan handle plates. Refer to the illustration below for visual details of the installation (click to enlarge).
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install Cable Management Bracket 
| Warning |
|---|
DO NOT INSTALL EITHER Sonus SONUS or TELECOM CABLES. You must complete the Initial Configuration before connecting the Sonus SBC 2000 system to your network. |
...
You are now ready to complete the initial configuration of the Sonus SBC 2000 system. Proceed to Running Initial Setup.
| Pagebreak |
|---|
Overview
Content Tools