Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 2

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migration of unmigrated content due to installation of a new plugin

...

  1. In the mounting hardware bag provided with the Sonus SBC 2000 system, find the rear support brackets (2) and 9-inch extension arms (2).
  2. If you are installing the Sonus SBC 2000 system into a 30-inch depth rack, attach the extension arms to the support brackets.

  3. Attach the support brackets securely to the two rear posts of your equipment rack. Refer to the illustration below for visual details of the assembly:

    Caption
    0Figure
    1Assemble And Install Rear Support Brackets

    Image Modified 

Note

The illustration above shows the rear bracket assembly for a rack with a 30-inch depth. For racks with a 24-inch depth, do not use the 9-inch extension arm and attach each support bracket directly to the rear rack posts.

...

  1. Attach the 2 rack mounting ears securely to the front corners of the Sonus SBC 2000 chassis.
  2. Attach the 2 pan handle plates securely to the rear corners of the Sonus SBC 2000 chassis.
  3. Working with a partner, lift the Sonus SBC 2000 chassis and slide it into the equipment rack, making sure to seat each pan handle plate into the support brackets mounted on the rear support posts.

  4. Attach the 2 rack mounting ears securely to the front mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).

     

    Caption
    0Figure
    1Install In 4-Post Equipment Rack

    Image Modified 

     

Warning

Do not block the air vents on either side of the Sonus SBC 2000 chassis. Both sides of the unit must clear to ensure proper cooling of the unit.

...

  1. Attach the 2 rack mounting ears securely to the center mounting points on both sides of the Sonus SBC 2000 chassis.

  2. Attach the 2 rack mounting ears securely to the mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).

     

    Caption
    0Figure
    1Install In 2-Post Equipment Rack

    Image Modified

     

Installing Interface Cards

...

Warning

You must power down the Sonus SBC 2000 system before installing or removing Interface Cards. Hot swapping of Interface Cards is not supported in Sonus SBC 2000 4.0.x.

 

 

Wiki Markup
{multi-excerpt-include:pageTitle=Inserting and Removing Interface Cards|name=insert|nopanel=true}

Installing Ground Wire, Power Cables and Connect Power

...

  1. Place the cable management bracket on top of the pan handle plates.

    Note

    If you have installed the Sonus SBC 2000 chassis in a 2-post configuration, you must install the pan handle plates on the rear corners of the chassis.

  2. Use the provided cable ties to secure the cable management bracket to the pan handle plates. Refer to the illustration below for visual details of the installation (click to enlarge).

     

    Caption
    0Figure
    1Install Cable Management Bracket

    Image Modified 

 

Warning

DO NOT INSTALL EITHER Sonus or TELECOM CABLES. You must complete the Initial Configuration before connecting the Sonus SBC 2000 system to your network.

...