Page History

Add_workflow_for_techpubs

AUTH1 UserResourceIdentifier{userKey=8a00a0c86ca23f8a016cd6ed6fe90013, userName='null'} REV5 UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'} REV6 UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'} REV3 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cd8b0a59, userName='null'} REV1 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cd8b0a59, userName='null'}

Panel
In this section: Table of Contents

This section describes how to enable

Spacevars
0 product3

 control of SD-WAN. To enable control of SD-WAN via

Spacevars
0 product3

, there are a few configuration prerequisites on

Spacevars
0 product2

. Configure these changes as mentioned below.

SD-WAN License

The 

Spacevars
0 longcompany

 SD-WAN requires a license that should be purchased separately. This license is available as a subscription or perpetual license. Ensure that your SD-WAN is licensed, to be able to control it via

Spacevars
0 product3

.

Enable WAN Link Redundancy

From the Configuration Menu, select Network > WAN Failover. Select Enable WAN Link Redundancy and Submit change.

Enable Traffic Shaping

From the Configuration Menu, select Network > Traffic Shaper. Select Enable Traffic Shaping and Submit change.

Info
title Note
To view  Spacevars 0 product2 devices on the  Spacevars 0 product3 Devices List page, configure the following parameters in the evagent.conf file: EVAGENT_ENABLE=on EDGEVIEW_HOST=”IP address”