Page History
Add_workflow_for_techpubs | ||||
---|---|---|---|---|
|
...
|
...
|
...
|
...
|
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product. |
The following workflow defines the procedures to deploy HA on an SBC SWe Edge.
Prerequisites Anchor Prerequisites Prerequisites
Before you begin, make sure you have the following:
- Hardware Requirements
- Two SBC SWe Edge instances ESXi host with
- a minimum of 4 vCPUs
- a minimum of 4 GB of RAM
- a minimum of 3 to a maximum of 5 virtual network interface cards (NICs):
- 1 for the Management port,
- 1 or 3 for Media/Packet ports
1 for the HA port
Info title Note Regardless of whether you choose to use 3 or 5 virtual NICs, the last Media/Packet port is converted to an HA port. You cannot configure the HA port for signaling and media call handling, as it is used for such purposes as fault detections and storing and retrieving data from the database store.
- all 5 network interfaces (mgt0, pkt0, pkt1, pkt2, pkt3) mapped through network configuration
- Two SBC SWe Edge instances ESXi host with
- Software Requirement
- HA supported version is installed on the system, for example, release 12.
...
- 1.
Ethernet Interface Requirements
Hide ATTENTION: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there.
Multiexcerpt | ||
---|---|---|
| ||
|
...
|
...
|
...
|
...
|
...
|
...
|
...
|
Workflow
Enabling High Availability on Active and Standby SWe Edge Instances
Anchor | ||||
---|---|---|---|---|
|
...
Enable HA on the Active and Standby SWe Edge instances
...
to
...
increase the stability of the system during mid-call failovers.
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there. |
Multiexcerpt | ||
---|---|---|
| ||
Start
|
...
|
...
|
...
|
...
|
...
|
...
|
...
Verifying High Availability Status
Anchor | ||||
---|---|---|---|---|
|
...
Verify the HA pair status
...
to ensure that both the Active and the Standby SBC SWe Edge instances are properly enabled.
Hide |
---|
ATTENTION: Content on this page is shared with the Edge 8000 product using the MultiExcerpt macro here and the MultiExcerpt Include macro there. |
Multiexcerpt | ||
---|---|---|
| ||
Start
|
...
|
...