Versions Compared

Old Version 3

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To View and Edit Overlap Dialing

On the SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Trunk Group > H323Trunk Group > H323 Trunk Advanced > H323 Trunk - Services - Advanced > Overlap Dialing. The Overlap Dialing window is displayed.

...

The Edit Overlap Dialing window is displayed.

Figure 1: H323 H323 Trunk Advanced - H323 Trunk - Services - Advanced - Overlap Dialing

The following fields are displayed:

Table 1: H323 Trunk Advanced - Overlap Dialing Parameters


Parameter Descriptions:

Parameter

Description

Overlap StateControl to determine if Overlap Dialing is supported.
  • disabledDisabled (default)
  • egressOnlyEgress Only – Select to enable egress overlap dialing only for a trunk group +both egress and ingress.
  • enabledEnabled – Select to enable overlap dialing. If the trunk group is being used for both ingress and egress, then both directions are enabled.
  • ingressOnlyIngress Only – Select to enable ingress overlap dialing only for a trunk group using both egress and ingress.
Min Digits For Query

Controls the number of called address digits to collect before performing the first policy query during overlap receiving.

If set to “0”, this parameter is irrelevant in controlling policy query. (Range: 0-30 / default = 0)

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.