Page History
| Panel | ||||
|---|---|---|---|---|
In this section:
|
| Info | ||
|---|---|---|
| ||
Related articles:
|
These objects specify the IP interfaces that the SBC will utilize for telephony, management, and system debugging traffic.
IP Interface Groups are a primary tool for accomplishing disjoint networks (administrative network separation). An IP Interface Group is the local manifestation of a segregated network domain.
| Note | ||||
|---|---|---|---|---|
| ||||
For the SBC 52x0 platform, the IP Interface on the media ports 0 and 1 are considered as the first set (example: set 1) and the IP Interfaces on media ports 2 and 3 are considered as second set (Example: set 2). While associating the interfaces to an IP Interface Group, the IP Interfaces associated to the group must be from the same set (set 1 or set 2). This should be set at the configuration level. |
| Note | ||||
|---|---|---|---|---|
| ||||
When calculating bandwidth size, keep in mind that an IPv6 header size (40 bytes) is twice as large as IPv4 header (20 bytes), thus reducing the number of messages when using IPv6. |
| Include Page | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
View an IP Interface Group
From the main menu, go to Configuration > System Provisioning > Category: Base Provisioning > IP Interface Group to open the IP Interface Group window.
System Provisioning - IP Interface Group
The IP Interface Group can be checked for each Address Context or for all the Address Contexts created. Use the drop-down box to select the desired Address Context.
Edit an IP Interface Group
To edit any of the IP Interface Groups in the list, click the radio button next to the specific IP Interface Group name.
The Edit Selected IP Interface Group window is displayed below.
IP Interface Group Edit Window
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
Create an IP Interface Group
To create a new IP Interface Group, click New IP Interface Group tab on the IP Interface Group List panel.
Figure 3: Ip Interface Group fields
The Create New IP Interface Group window is displayed.
IP Interface Group Create Window
The following fields are displayed:
IP Interface Group Parameters
Parameter | Description | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
Name | The name of the IP interface group. | |||||||||||
IPsec | The administrative state of a resource. Administrative state of the IPsec support for this interface group.
Note: PING does not work when IPSec is enabled on the IP interface. | |||||||||||
| IPsec For Media |
The parameter IPsec For Media in the IP Interface Group EMA screen supports media over IPsec. The IPsec For Media parameter works in conjunction with the IPsec state parameter already available in the same screen. The IPsec Admin State field enables or disables IPsec on the LIF Group as a whole.
Whenever IPsec For Media is disabled, only media SAs are deleted. If only IPsec is disabled, then only the signaling/LI SAs are deleted. Currently, whenever IPsec is disabled on a LIF group, isakmp ports on the interfaces belonging to the LIF group are closed. If IPsec is disabled on LIF group but IPsec for Media is enabled, then isakmp ports are not closed, and vice versa. To establish IPsec SAs for media traffic, enable IPsec For Media of a media IP Interface Group as well as the administrative "state" of media IPsec SPD.
|
Enter all the required fields. You can click Show only required fields at the left hand bottom of the panel to view and enter only the required fields to create a IP Interface Group.
Delete an IP Interface Group
To delete any of the created IP Interface Group, click the radio button next to the specific IP Interface Group which you want to delete.
Click Delete at the end of the highlighted row. This will open a delete confirmation message.
Click Yes to remove the specific IP Interface Group from the list.
Overview
Content Tools